Safety Notes

19 US-EN
Connecting the transmitter to existing bell
systems or an existing doorbell button
Remove the holder
12
by pressing the lock
11
from the back of
the transmitter and remove the rubber cover
16
(see fig. C1).
Open the inner cover
14
using a Phillips screwdriver (see fig. F).
Remove the plastic clip of cable exit hole
19
with a flat head
screw driver (see fig. G).
Insert the cable through cable holder
20
and cable exit hole
19
(see fig. H).
Connect cable to terminals A and C (for connecting to existing
doorbell) or terminals B and C (for connecting to existing doorbell
button) using screw driver (see fig. H).
Connecting the transmitter to an existing
bell system (see Fig. I)
Extension of an existing doorbell system:
An already existing doorbell system can be extended with this product.
The operating voltage of the doorbell system must be between 4–12 V.
It makes no difference whether this comes from direct current or 50 -
60 Hz alternating current. In the event that you are dealing with an
existing doorbell system using direct current, you must connect the
positive terminal of the doorbell to contact C of the transmitter and
the negative terminal to contact A of the transmitter.
320257_silv_Design-Funktuerklingel_content_US.indd 19 01.03.19 12:13