Users Manual

GFGT 433 B1
14 - US-EN
• Now unfold the folding clip (10) so you can open the battery
compartment cover (13) into the direction of the arrow.
• Insert two AAA 1.5 V (Micro/R03/LR3) batteries, making sure
the polarity is correct. Refer to the diagram inside the battery
compartment (12).
• Close the battery compartment (12) by replacing the cover
(13) and pushing it in the opposite direction to the arrow.
7.2 Connecting the temperature sensors (30; 31)
Before using it for the first time, remove the transport protection
(black rubber cover) from the tips of the temperature sensors (30;
31).
Insert the connectors (27; 28) into the sockets (25; 26) on the side
of the transmitter (14).
When not in use, you can wind the temperature sensor (30; 31)
cables around the transmitter and fix the temperature sensors on the
transmitter (14) top. There is an additional plastic nose for this
purpose.
7.3 Selecting the temperature unit
You can choose between two temperature units (°C and °F). On
the receiver, you can do this using the selection button (6). On the
transmitter (14), slide the selector switch (22) on the back panel to
the desired position.