User's Manual

14 US-EN
Plug the micro-USB plug
12
on the charging cable into the mi-
cro-USB socket
11
on the headphones! Plug the USB plug
13
on
the charging cable into the USB port on a PC or a USB adapter.
Note: The LED will flash red and blue whilst charging. Once the
battery is fully charged, the LED will remain blue.
Once charging has completed, remove the micro-USB plug from
the headphones.
Using the headphones
Connect the headphones with a communication device.
Place the headphones near a switched on communication device
(e.g. mobile or computer).
Pairing with a new Bluetooth
®
device: Hold the button
8
for 6 seconds until the LED
5
flashes red and blue and you hear
two beeps. This indicates the headphones are now in pairing mode,
which remains active for 5 minutes. The headphones will switch off
if they do not detect a Bluetooth
®
device to connect to and sound
4 beeps.
Now connect your communication device (mobile phone or com-
puter) via Bluetooth
®
with the headphones. Please refer to the notes
in the instructions for your communication device. Select the entry
“HG00593“ from the list of devices detected by your computer or
mobile. If prompted, enter code “0000“ to establish the connection.
Once the connection has been established, the LED will briefly flash
twice every 4 seconds.
If you want to connect a another device to the headphones, repeat
the pairing as described previously.
Please note, your communication device must support Bluetooth
®
Standard 4.0 to use all options.
285814_silv_Bluetooth-Kopfhoerer_content_US.indd 14 13.03.17 13:03