Power Supply - UPS User Manual
Table Of Contents
- Important Safety Instructions
- About This Manual
- 1.0 Introduction
- 2.0 Theory of Operation
- 3.0 Operation
- 3.1 Display Screen and Operator Controls
- Features
- Figure 9 Operator Controls, 150 to 225 kVA (left) and 300 to 450 kVA (right)
- Figure 10 Operator Controls, 338 to 1000 kVA (SCR-Based Modules)
- Figure 11 System Control Cabinet Operator Controls (SCCB Pictured)
- Figure 12 Series 600 UPS and SCC Operator Control Panels
- Figure 13 Switches Behind Control Panel Door (338-1000 kVA SCR-Based Modules)
- Figure 14 Menu Tree
- 3.1.1 Master Menu Screen
- 3.1.2 Monitor/Mimic Display Screen
- Figure 16 SCC Monitor/Mimic Display Screen
- Input Metering Displays
- Output Metering Displays
- Status/Alarm Message Areas
- Figure 17 Module Monitor/Mimic Display Screen
- Input Metering Displays
- Output Metering Displays
- Alarm Messages
- Figure 18 Monitor/Mimic Display Screen Examples: Normal Power Flow
- Figure 19 Monitor/Mimic Display Screen Examples: Utility Fail
- Figure 20 Monitor/Mimic Display Screen Examples: Load On Bypass, UPS Modules On and Charging Battery
- Figure 21 Monitor/Mimic Display Screen Examples: Load On UPS, One UPS Module Off Line
- Figure 22 Monitor/Mimic Display Screen Examples: Load On Bypass, All UPS Modules Off Line
- 3.1.3 Walk-In Display Screen
- 3.1.4 Status Reports Screens
- Figure 24 Status Reports Screen
- Present Status
- Figure 25 Present Status Report Screen
- Event History
- Figure 26 Event History Report Screen
- History Status
- Figure 27 History Status Report Screens
- System Status
- Figure 28 Battery Cycle Monitor Screen
- Figure 29 Battery Cycle Monitoring Summary Screen
- Figure 30 Typical Data on Discharge Cycles of 91 to 240 Seconds Duration During the Recording Period
- 3.1.5 System Configuration Screens
- 3.1.6 Alarm Limit Settings Screen
- 3.1.7 Load Transfer Procedures
- 3.1.8 Start-Up Procedures Screen
- 3.1.9 Shutdown Procedures Screen
- 3.1.10 Battery Time Screen (Module Only)
- 3.1.11 Meter Calibration Screen
- 3.1.12 Battery Equalize Screen
- 3.1.13 Alarm and Status Messages
- 3.1.14 Communication Interfaces
- 3.2 Modes of Operation
- 3.3 Manual Procedures
- 3.4 Automatic Operations
- 3.1 Display Screen and Operator Controls
- 4.0 Maintenance
- 5.0 Specifications and Ratings
ìëëýýýýýýýýýý6SHFLILFDWLRQVýDQGý5DWLQJV
&5,7,&$/ý/2$'ý287387
2XWSXWý9ROWDJHãý 6WDQGDUGýYROWDJHV¥ëíå<îìëíý9$&ñýéåí<îëææý9$&ñýçíí<îêéçý9$&ïý2WKHUý
YROWDJHVýDYDLODEOHýRQýUHTXHVWïýê
ðSKDVHñýêðZLUHýSOXVýJURXQGýRUýêðSKDVHñýéðZLUHý
SOXVýJURXQGïý
2SWLRQDOýYROWDJHV¥ëíåý9$&ñýéåíý9$&ñýçííý9$&ïý2WKHUýRSWLRQDOýYROWDJHVý
DYDLODEOHýRQýUHTXHVWïýê
ðSKDVHñýêðZLUHýSOXVýJURXQGýõXQJURXQGHGýRUýFRUQHUý
JURXQGHGýGHOWDôïý
9ROWDJHý5HJXODWLRQãý ‘íïèøýIRUýEDODQFHGýORDGïý
‘ëøýIRUýXQEDODQFHGýORDGïý
9ROWDJHý$GMXVWPHQWý5DQJHãý ‘èøýPDQXDOO\ïý
/LQHý'URSý&RPSHQVDWLRQý5DQJHãý 8SýWRýòèøýDXWRPDWLFýORDGýGHSHQGHQWïý
)UHTXHQF\ èäïèý+]ýWRýçíïèý+]ïý
6OHZý5DWHãý íïíçý+]ýSHUýVHFRQGïý
3KDVHý%DODQFLQJãý ìëíƒý‘ìƒýIRUýEDODQFHGýORDGVïý
ìëíƒý‘êƒýIRUýèíøýXQEDODQFHGýORDGVïý
9ROWDJHý,PEDODQFHã
ëíøý8QEDODQFHGý/RDG
èíøý8QEDODQFHGý/RDG
‘ìøýIURPýWKHýDULWKPHWLFýDYHUDJHýRIýWKHýêýSKDVHVïý
‘ëøýIURPýWKHýDULWKPHWLFýDYHUDJHýRIýWKHýêýSKDVHVïý
9ROWDJHý7UDQVLHQWãý
ëíøý/RDGý6WHSý
êíøý/RDGý6WHSý
ìííøý/RDGý6WHS
/RVVýRUý5HWXUQýRIý$&ý,QSXWý3RZHUý
0DQXDOý7UDQVIHUýRIýìííøý/RDGý
‘éøýIURPýWKHýDYHUDJHýSHDNýYROWDJHï
‘èøýIURPýWKHýDYHUDJHýSHDNýYROWDJHï
‘æøýIURPýWKHýDYHUDJHýSHDNýYROWDJHï
‘ìøýIURPýWKHýDYHUDJHýSHDNýYROWDJHï
‘éøýIURPýWKHýDYHUDJHýSHDNýYROWDJHï
9ROWDJHý7UDQVLHQWý5HFRYHU\ý7LPHãý 7RýZLWKLQýìøýRIýVWHDG\ýVWDWHýRXWSXWýYROWDJHýZLWKLQýèíýPLOOLVHFRQGVïý
9ROWDJHý+DUPRQLFý&RQWHQWãý 0D[LPXPýèøý506ýWRWDOñýIRUýDQ\ýFRPELQDWLRQýRIýOLQHDUýDQGýQRQOLQHDUýORDGVïý
0D[LPXPýêøý506ýVLQJOHñýIRUýOLQHDUýORDGVïý
2YHUORDGýDWý)XOOý2XWSXWý9ROWDJHãý ìíéøýRIýIXOOýORDGýUDWLQJýFRQWLQXRXVO\ïý
ìëèøýRIýIXOOýORDGýUDWLQJýIRUýìíýPLQXWHVïý
ìèíøýRIýIXOOýORDGýUDWLQJýIRUýêíýVHFRQGVïý
õZLWKý‘ëøýYROWDJHýUHJXODWLRQôïý
)DXOWý&OHDULQJã êííøýRIýQRUPDOýIXOOýORDGýFXUUHQWýVXEF\FOHï
ìíííøýRIýQRUPDOýIXOOýORDGýFXUUHQWýXSýWRýéíýPLOOLVHFRQGVýZLWKýE\SDVVýDYDLODEOHïý