User manual

Options—Installation
14
4.2 1U Tool-Less Fixed Shelf Installation
The 1U tool-less fixed shelf (Part # 002185000) has tabs on the front and rear that slip into square
holes in the 19" rails. The shelf has a maximum load rating of 150 lb. (68kg).
Figure 10 1U tool-less fixed shelf installation point
4.3 1U Tool-Less Telescopic Shelf
The 1U telescopic shelf (Part # 535809G1) has tabs on the upper half of the front and rear to hold it
in place. The telescopic slide is assembled and attached to the shelf for shipping. The shelf has a
maximum load rating of 110 lb. (50kg).
To install the shelf:
1. Pull the telescopic slide toward the back of the shelf.
2. Press the lock on the telescopic slide and pull the slide off the shelf. The locks work in opposite
directions: press down on the lock on one side to release it; press up on the other lock to release it.
3. Repeat Steps 1 and 2 for the telescopic slide on the other side of the shelf.
4. Hang the telescopic slide on the rack’s rails with the tabs on the upper half of the telescopic slide
(see Figure 11).
Make sure that the front and rear tabs are level; the tabs should be slots with the same number.
5. Repeat Step 4 for the second telescopic slide. Make sure the telescopic slides are level.
6. Slide the shelf into the slide until it reaches the back, securing the components. The shelf will
enter more easily if it is kept square with the telescopic slides. The front of the shelf has a notch to
grasp it when pulling the shelf out (see bottom portion of Figure 11).
NOTE
Do not tilt the back of the 1U tool-less fixed shelf down without securing the extensions. The
extensions do not have a positive stop fixture to keep the extensions from falling out.
Tab hooks in slot
in rail
Front Corner
of Shelf