Operating and installation instructions Combined fridge-freezer with BioFresh compartment for integrated use, door-on-door 110309 7084282 - 01 ICB/ICBP/ICBN/SICBN ...
Appliance at a glance Contents 1 1.1 1.2 1.3 1.4 Appliance at a glance............................................ Range of appliance use............................................ Conformity................................................................ Description of appliance and equipment.................. Net@Home............................................................... 2 2 2 3 3 2 General safety information................................... 3 3 3.1 3.2 Controls and displays............
General safety information 1.3 Description of appliance and equipment 1.4 Net@Home The appliance can be provided with the retrofit modules for the HomeDialog system or the serial interface (RS 232), depending on model and equipment. The modules are available from your specialist dealer. You will find more information on the internet at www.liebherr.com.
Controls and displays - Do not reach into the soft stop mechanism. Fingers may be trapped when the door is closed. Please observe the specific information in the other sections: DANGER identifies a situation involving direct danger which, if not obviated, may result in death or severe bodily injury. WARNING identifies a dangerous situation which, if not obviated, may result in death or severe bodily injury.
Putting into operation 4.2 Water connection* 4.1.2 To change the hinges WARNING Danger of electric shock! u Disconnect the appliance by unplugging it before you connect it to the water line. u Shut off the water supply before you connect the water feed lines of the IceMaker. u The connection to the drinking water system may be carried out only by a qualified gas fitter and plumber. WARNING Risk of poisoning! u The water quality has to comply with the drinking water ordinance of the respective country (e.
Putting into operation Fig. 6 Make sure the following tools are on hand: q Cordless screwdriver Torx®15, 20, 25 q Spanner 13, Spirit level The intermediate base and side wall of the kitchen unit have to be at right angles to one another. Align the kitchen unit using a spirit level and angle. If necessary, use shims. The appliance can also be installed in an ordinary kitchen cabinet. In this case detach the fittings of the unit door and recess.
Putting into operation u Fit the equaliser trim Fig. 10 (20) concentrically onto the appliance: Slide it into the recess and engage it in the keyholes. 4.3.1 Installing the appliance u Screw all the mounting brackets Fig. 11 (34) to the pre-drilled holes in the appliance door using hexagon screws Fig. 11 (35). For 16 mm-thick unit walls = 568 mm-wide recess: u Clip spacer Fig. 12 (23) onto the upper hinge and spacer Fig. 8 (24) onto the lower hinge. u Attach the top cover Fig.
Putting into operation u Vertically align the appliance by means of the adjustableheight feet Fig. 8 (25), using the accompanying open-ended spanner Fig. 8 (26). w The appliance is now correctly positioned in depth. The distance from the front edge of the side wall of the unit to the appliance body is 42 mmall the way round. (Allow for door stop components, such as knobs and sealing lips.) Note Incorrect installation will lead to malfunction! If the distance is not kept, the door may not close.
Putting into operation Check the following points to ensure the appliance is fitted properly. Failure to do so may lead to icing, condensate forming and malfunction: w The door has to close properly w The unit door must not butt against the unit body w The seal must have a firm fit at the upper corner on the handle side. To check, darken the room, place a torch inside the appliance at the top and close the door. If light shines through, check the assembly. Fig.
Control u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because otherwise there will be vibratory noise! After installation: u Remove the protective film from the decorative trims and drawer fronts. u Remove all transit supports. u Dispose of packaging material (see 4.6) . NOTICE Risk of damage due to condensate! If your appliance is not a Side-by-Side (SBS) appliance: u do not install the appliance directly alongside a further refrigerator/freezer.
Control u To switch off: Using the Up setting button, freezer compartment Fig. 2 (5) or Down setting button, freezer compartment Fig. 2 (4), select c0. u To confirm: press SuperFrost button Fig. 2 (2). w When the child lock symbol Fig. 2 (8) shines, the child lock is activated. u To deactivate the set-up mode: press On/Off button, freezer compartment Fig. 2 (3). -oru Wait for 5 minutes. w The temperature is indicated again in the temperature display. 5.
Control 5.6.4 Relocating the shelves The shelves have stops preventing them from being unintentionally pulled out. When the drawer is well filled, a dewy climate with up to 90% humidity is established. The humidity in the compartment depends on the moisture content of the food stored and on the opening frequency. You can set the humidity yourself. 5.7.2 DrySafe The DrySafe is suitable for storing dry or wrapped food (e.g. dairy products, meat, fish, sausages).
Control Standard values for storage time at high humidity Mushrooms up to 7 days Radishes up to 10 days Brussels sprouts up to 20 days Asparagus up to 18 days Spinach up to 13 days Savoy cabbage up to 20 days 5.7.6 Setting the humidity in the HydroSafe u u Low humidity: move the regulator to the left. High humidity: move the regulator to the right. 5.7.
Control 5.8.3 Setting the temperature in the freezer compartment The appliance is pre-set for normal operation. The temperature can be set between -16 °C and -26 °C / Australia model -14 °C and -26 °C, the recommended temperature is -18 °C.* u To set the temperature higher: press Up button, freezer compartment Fig. 2 (5). u To set the temperature lower: press Down button, freezer compartment Fig. 2 (4).
Maintenance u Store freezer bags or containers in a drawer. u To thaw the items, spead them out loosely again. 5.8.10 Cold storage accumulators The cold storage accumulators prevent the temperature from rising too fast in the event of power failure. For optimal cooling in case of failure, place the cooled cold storage accumulators on the frozen food in the top, front area of the freezer compartment.
Maintenance u Pay attention that the defrost water does not run into the kitchen unit. * u If necessary, pick up defrost water several times, using a sponge or cloth.* u Clean the appliance (see 6.3) and rub dry.* u Wipe dry the appliance and items of equipment. u Connect the appliance and switch it on again. u Switch on SuperFrost (see 5.8.4) . When the temperature is sufficiently cold: u Put the food back inside. 6.2 Defrosting with NoFrost* 6.
Malfunction u Pull out the mains plug (not by pulling the connecting cable) or switch off the fuse. 7 Malfunction Your appliance is designed and manufactured for a long life span and reliable operation. If a malfunction nonetheless occurs during operation, check whether it is due to a handling error. In this case you will have to be charged for the costs incurred, even during the warranty period. You may be able to rectify the following faults yourself: Appliance does not work.
Decommissioning 8 Decommissioning 8.1 Switching off the appliance Note u To switch off the entire appliance it is necessary only to switch off the freezer compartment. 8.1.1 Switching off the freezer compartment u Press On/Off button, freezer compartment Fig. 2 (3) for about 2 s. w The temperature displays are dark. The appliance is switched off. 8.1.2 Switching off the refrigerator compartment with BioFresh compartment Note u The refrigerator compartment can be switched off separately, if required.