Installation instructions For NoFrost combined refrigerator-freezers Page 6 GB 7082 375-00 CBNes 62 410
GB Setting up • Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. • The floor on which the appliance stands should be horizontal and level. • The ventilation grilles should not be obstructed. Always ensure that there is good ventilation and that the outward flowing air is able to escape. • Do not place heat-emitting appliances, e.g. microwave oven, toaster, etc., on top of the appliance.
GB Fitting the top anti-tipping bracket Ice maker 1. Mount the anti-tipping bracket provided on the wall using 6 x 60 screws. The ice maker is fitted in the freezer compartment of the combined refrigerator-freezer. It must be connected to the mains water supply to work. Safety instructions and warnings • Do not connect to the water supply while the combined refrigerator-freezer is connected to the electricity supply. • The connection to the mains water supply may only be made by trained personnel.
GB Connection to the water supply The water pressure must be between 0.15 and 0.6 MPa (1.5 6 bar). 3. Push the appliance to the wall until the compressor mounting plate touches the anti-tipping bracket. Important: If the water filter is inserted in the appliance, the water pressure must lie between 0.3 and 0.6 MPa (3 - 6 bar). If the water pressure with the inserted water filter is too low, this may cause the ice maker to malfunction.
GB Levelling the appliance 1. Adjust the height of the appliance at the front by twisting the adjustable feet (A/F 27). 1 Caution! The front feet of the appliance must be firmly placed on the floor. Mounting the dust filter The supplied dust filter prevents that dirt enters the motor compartment, reducing the refrigeration performance. Therefore always install the dust filter. 1. Pull the bottom freezer drawer right out. 2. Remove the protective film from the dust filter.