"NoFrost"combined refrigerator-freezers and IceMaker Use and Care Manual C 16, CI 16, CS 16

13
REFRIGERATOR COMPARTMENT
Replacing the bulb:
!
WARNING
To prevent possible injury due to an
electrical shock, be sure to discon-
nect the power cord or turn OFF the
circuit breaker before replacing the
interior light bulb(s) or cleaning the
appliance.
CAUTION
!
To prevent possible injury due to broken
glass, use hand protection when replacing
the interior light bulb(s).
KGNves009
1
2
3
Figure 10
1. Remove the two screws securing the cover
(Fig. 10,
1
). Pull the cover straight out.
2. Remove the glass plate (Fig. 10,
2
).
3. Remove the defective bulb. Make sure the seal
(Fig. 10,
3
) is placed on the new bulb before
installing it.
4. Install the glass plate and cover.
Vegetable Drawer - Figure 9
KNGves00
8
Figure 9
To remove the vegetable drawer:
Pull the drawer straight out, grip at the back and lift
out.
To install the vegetable drawer:
Place the drawer on the rails. The rails must be fully
extended and aligned with the front of the drawer.
Slide the drawer in.
Interior Light
This turns OFF automatically after the door has
been opened for approximately 15 minutes. If it
does not turn ON when the door is opened briefly,
but the temperature display is working, the bulb(s)
may be defective.
The light is located behind the cover located at the
top of the refrigerator compartment and has two
bulbs.
Bulb data:
120 V, Maximum wattage - 25 W
Bulb fitting - E14
Current and voltage must agree with details on the
model plate.