DesignGuide Freestanding SemiBuiltIn 24 and 48 inch

Freestanding/Semi Built In Models
CS 1200, CS 1311, 1360 - SBS 26S1
Minimum Cabinet
Opening Dimensions:
A. 47-3/4" (1212 mm)
B. 24" (609 mm)
C. 85-7/8" (2182 mm)
D. 80" (2032 mm) *
Cabinet Opening Dimensions SBS 26S1
3"
(76 mm)
Unit Venting
DO NOT restrict the air flow. A cross-sectional air flow of at least
62" square (400cm ²) must be provided. The opening can either
be directly over the appliance or behind of the cabinet on top of
the unit (see ventilation requirements).
The appliance can be integrated into the kitchen units.
To adapt the appliance to the height of the row of kitchen units,
a suitable top cupboard can be fitted above the appliance.
The SBS 26S1 model can be installed in standard 24" (609mm)
deep cabinets. You will only have to make sure that the door
swing clearance is enough. It is possible to push the SBS 26S1
to the rear wall of the cabinet without modification.
When installing the appliance next to a wall, a distance on the
hinge side of 1 13/32 inches (36 mm) minimum is required be-
tween the appliance and the wall to allow for the door handle
projection when the door is open.
*Note:
The given cabinet opening height
dimension is such that it accom-
modates the ventilation require-
ments for the appliance. If you will
be bringing the cabinet above or
header of the opening down tight
(no air space - refer to the section
'Top Door Hinge Clearance' later
in this Design Guide) to the top
of the appliance for a built-in look
then you still must accommodate
ventilation by some other means.
The warm air from behind the ap-
pliance must be able to escape.
Please refer to the section 'Ventila-
tion Requirements' further on in
this Design Guide.
6