Use and Care Manual

u
Snap both cover
Fig. 8 (11) and cover Fig. 8 (10) into
place on the opposite side.
u
Leave upper door open.
4.3.11 Fitting the upper soft stop damper
Fig. 16
u
Loosen cover Fig. 16 (9) from the panel Fig. 16 (1) and
insert on the other side.
u
With the hinge of the upper soft stop unit facing the
door hinge side, engage the soft stop unit (A) and
swivel inwards (B)
w
The holes on the left and right must lie exactly above
each other
u
Tighten soft stop unit (2 x Torx® 15) Fig. 16 (7) .
Note
u
Follow the correct sequence First hang the panel over
the damper bracket, then the cover
Fig. 17
u
Hook panel Fig. 17 (1) into the damper bracket Fig. 17 (4)
such that the detent hooks are pointing inwards and the
front side is facing the appliance.
u
Push on cover Fig. 17 (5) from the outside (A) and pivot
over the bearing part Fig. 17 (8) (B).
u
Place cover Fig. 17 (5) on top and allow to snap into
place until the first notch.
w
The openings for the bolts lie above each other after
positioning the damper bracket
u
Pull damper bracket Fig. 17 (4) towards bearing bracket
and insert bolt Fig. 17 (3) from above such that the
square is resting in the recess.
u
Now snap cover
Fig. 17 (5) completely into place on the
bearing part Fig. 17 (8) .
w
Check that the cover is positioned correctly such that
the door can close properly and the bolt is secured
u
Remove locking device Fig. 17 (2) by twisting it.
u
Snap panel Fig. 17 (1) into place on the door.
u
Turn cover Fig. 6 (6) 180° from the handle side, place it
on top from the outside and snap into place.
4.3.12 Aligning the doors
u
Align the doors flush with the appliance housing, using
the two oblong holes in the lower bearing bracket
Fig. 12 (45) and in the center bearing bracket Fig. 11 (31)
as a guide, if needed. To do so, unscrew the center
screw on the lower bearing bracket Fig. 12 (45) .
WARNING
Risk of bodily injury due to the door falling off.
If the bearing parts are not installed with the proper
torque, the door may fall off. In addition, the door may not
close, thus impairing the cooling performance of the appli-
ance.
u
Securely tighten the bearing brackets by applying a
torque of 3 lb-ft (4 Nm).
u
Check all screws and retighten if necessary.
4.4 Side-by-side installation
As seen from the front, install the appliance with an
IceMaker on the right and the appliance without an
IceMaker on the left.
Fig. 18
The fixing accessories are supplied with model CS 1311.
If you have model CS 1360 you can purchase the fixing
accessories by contacting customer services.
Start-up
10 * Depending on model and options