Use and Care Manual

Switch on the appliance 2 hours before loading
with frozen food for the first time.
Do not load frozen foods until the temperature
display reads 0 °F (-18 °C).
4.11.1 Switching on the freezer compart-
ment
u
Press On/Off button, freezer compartment Fig. 4 (13) .
w
The fridge compartment temperature display shows the
current temperature in the interior.
w
The freezer compartment temperature display and the
Alarm symbol will flash until the temperature is cold
enough. If the temperature is greater than 32 °F (0 °C),
flashing dashes will appear; if the temperature is lower
than this, the current temperature will flash on the
display.
w
Whenever “DEMO” appears on the display, the appli-
ance is running in demonstration mode. Contact the
customer service department.
4.11.2 Switching on the fridge compartment
u
Press Fridge compartment On/Off button Fig. 4 (3) .
w
The interior light comes on when the door is opened.
w
The temperature display flashes. The fridge compart-
ment is switched on.
5 Operation
5.1 Temperature display unit
The temperature display can be changed from °F to °C.
5.1.1 To change the unit
u
Activate setting mode: Press SuperFrost button
Fig. 4 (14) for about 5 seconds.
w
S is displayed in the temperature display.
w
The Menu symbol Fig. 4 (19) lights up.
u
Using Freezer compartment Up button
Fig. 4 (11) / Freezer compartment Down button
Fig. 4 (12) select °.
u
To confirm: Briefly press SuperFrost button
Fig. 4 (14) .
u
Using Freezer compartment Up button
Fig. 4 (11) / Freezer compartment Down button
Fig. 4 (12) select °F or °C.
u
To confirm: Briefly press SuperFrost button
Fig. 4 (14) .
u
To exit setting mode: Press Freezer compartment
On/Off button Fig. 4 (13) .
-or-
u
Wait 5 minutes.
w
The temperature is again displayed in the temperature
display.
5.2 Brightness of the temperature
display
You can adapt the brightness of the temperature display
to the light conditions in the room in which it is installed.
If the door is open or the control panel is used the temper-
ature indicator lights up at maximum brightness. About 1
minute after the door is closed or no button has been
pressed on the control panel, the temperature display
goes back to the set brightness.
5.2.1 Setting the brightness
The brightness can be set between h0 (minimum lumi-
nosity) and h5 (maximum luminosity).
u
To activate setting mode: Press SuperFrost button
Fig. 4 (14) for about 5 seconds.
w
S is shown on the display.
w
The Menu symbol Fig. 4 (19) lights up.
u
Press Freezer compartment Up button Fig. 4 (11) or
Freezer compartment Down button Fig. 4 (12) to select
h.
u
To confirm: Briefly press SuperFrost button Fig. 4 (14) .
u
To set the display brighter: Press Freezer
compartment Up button
Fig. 4 (11) .
u
To set the display darker: Press Freezer
compartment Down button Fig. 4 (12) .
u
To confirm: Press SuperFrost button
Fig. 4 (14) .
w
The brightness is set to the new value.
u
To deactivate setting mode: Press Freezer compart-
ment On/Off button Fig. 4 (13) .
-or-
u
Wait 5 minutes.
w
The temperature is again displayed in the temperature
display.
5.3 Child-proof lock
You can use the child-proof lock to lock the
buttons. This means that children cannot acci-
dentally switch off the appliance when playing.
5.3.1 Switching on the child-proof lock
u
Activate setting mode: press and hold the SuperFrost
button
Fig. 4 (14) for approximately 5 s.
w
S is shown on the display.
w
The Menu symbol Fig. 4 (19) lights up.
u
Using the Freezer compartment Up button Fig. 4 (11) or
Freezer compartment Down button Fig. 4 (12) , select c.
u
Press the SuperFrost button
Fig. 4 (14) briefly to
confirm.
When
c1 is shown on the display:
u
To switch on the child-proof lock, press the
SuperFrost button
Fig. 4 (14) briefly.
w
The Child lock symbol Fig. 4 (16) LED lights up. c
flashes on the display.
Operation
18 * Depending on model and options