Use and Care Manual

10
o peraTion
= WaterquantityforIcecubetray
If the produced ice cubes of the ice maker are too
small, the inflowing water quantity can be adjusted.
• ActivatethesetupmodebytouchingtheSuperFrost
icon for 5 seconds.
• Touch the freezer compartment Down icon until
appears in the freezer temperature display.
• TouchtheSuperFrost icon
- the display shows
• Touchfreezer compartment Up icon
once only so E 4 appears in the display.
IMPORTANT
Do not increase for more than one step. If the
adjusted value is too high, the ice cube tray of the
ice maker could overflow.
• TouchtheSuperFrost icon again.
• Exitsetupmodebytouchingthefreezercompartment
On/Off icon.
Checktheicecubesizewithinthenextdays.Ifthe
ice cubes are still smaller as desired, follow the steps
above again.
= Ice maker function test
Activation by service personnel only.
= Display brightness
Adjusting the display brightness
• ActivatethesetupmodebytouchingtheSuperFrost
icon for 5 seconds.
• Touchthefreezer compartment Down icon until
appears in the freezer temperature display.
• TouchtheSuperFrost icon
- the display shows
• Touchfreezer compartment Up/Down icons to select
0 = minimum to
5 =maximumbrightness
• TouchtheSuperFrost icon at the desired value.
• Exitsetupmodebytouchingthefreezercompartment
On/Off icon.
• Close the appliance door. The adjusted brightness
will be activated after one minute.
= Drop symbol reset
After the Water filter
(optional
accessory)
has been changed the
drop symbol on the display must
be reset.
• ActivatethesetupmodebytouchingtheSuperFrost
icon for 5 seconds.
• Touchthefreezer compartment Down icon until
appears in the freezer temperature display.
• TouchtheSuperFrost icon
- the display shows
• TouchtheSuperFrost icon again
- the display shows
• Thedropsymboldisappears.
• Exitsetupmodebytouchingthefreezercompartment
On/Off icon.