Design Guide Freestanding / Semi Built-In Models 24" and 48" Release 11 2015
Welcome Liebherr is one of the World’s leading Manufacturers of Premium Refrigeration. For more than 60 years, Liebherr has specialized in developing and manufacturing first class refrigerators and freezers as well as wine cabinets. We focus on performance and efficiency as well as keeping food fresher longer. Produced in Austria and Germany, Liebherr has a full line of premium models tailored specifically for the North American marketplace to fit any design vision you have for your kitchen.
Introduction LIEBHERR WARRANTY PLAN FULL TWO YEAR WARRANTY - For two years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any part of the product which proves to be defective in materials or workmanship. FULL FIVE YEAR WARRANTY - For five years from the date of original purchase, your Liebherr Warranty covers all parts and labor to repair or replace any components that prove to be defective in materials or workmanship in the sealed system.
Contents General Remarks I. Safety Warnings......................................................................................................................................... 7 II. Electrical Requirements & Safety............................................................................................................ 8 III. IceMaker (if equipped)............................................................................................................................. 8 IV.
General Remarks I. Safety Warnings PLEASE READ AND FOLLOW THESE INSTRUCTIONS This design guide contains Warning and Caution statements. This information is important for safe and efficient installation. This design guide is not replacing the use and care manual which contains important information on how to use Liebherr appliances. Always read and follow all Warning and Caution statements! States a hazard that may cause serious injury or death if precautions are not followed.
General Remarks II. Electrical Requirements & Safety III. IceMaker (if equipped) Circuit has to be grounded and protected by a circuit breaker or fuse. Single installation: Side-by-side installation: • 115 volt • 115 volt • 60 hz • 60 hz • 15 amp • 20 amp The icemaker is located in the freezer compartment. It must be connected to the water supply to function properly. The appliance must be level for the icemaker to function properly.
General Remarks IV. Area Requirements V. Safety Regulations Verify the following: • Floors can support refrigerator’s weight plus approximately 1200 pounds (544 kg) of food weight. Not all Liebherr products are designed for 1200 pounds (544 kg) of food. Some units are smaller and total weights may vary. The appliance complies with UL250 and CAN/CSA C22.2 No.63-93 and is designed to cool, freeze, store food as well as make ice (if equipped). It is designed as a household appliance.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B The unique design of Liebherr's freestanding models features fully stainless steel doors, and even stainless steel side walls - a perfect combination of design and functionality. New Swing Line doors with bevelled edges are a particularly elegant feature of this combination.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B SBS 26S1 (CS 1311 & CS 1360) Energy Supply: Total capacity: Refrigerator: Freezer: Ice cube capacity: Ice cube stock: Climate Rating: Door hinges: 115V/60Hz/700W 26 cu ft (738 L) 19.4 cu ft (550 L) 6.6 cu ft (188 L) 2.2 lbs./24h 3.3 lbs.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B NOTE The doors of these models are Liebherr's Smartsteel . The sidewalls are not. Use only a damp cloth and / or mild detergent to clean the Smartsteel doors. Abrasive or aggressive cleaners or cloths will damage the Smartsteel finish. CS 1200 °C Ventilation 9 7 5 3 1 -15 -18 -21 -25 -32 Energy Star: certified Energy consumption p. a.: 416 kWh Energy Supply: 115V/60Hz/350W Total capacity: 11.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B 13
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Unit Dimensions CS 1311, CS 1360, CS 1200, CS 1350B (A) 2-7/32" (56.5 mm) (B) CS13.. : 79-3/16" (2011 mm) CS12.. : 71-9/16" (1817 mm) (C) 23-5/8" (600 mm) (D) 25-3/16" (640 mm) (E) 24-3/16" (614 mm) (F) 24-13/16" (630 mm) (G) 46-1/2" (1180 mm) NOTE Height dimension (B) represents the minimum height of the appliance(s) as measured from the floor to top of the door hinge cover.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Kitchen cabinet setup for the water filter To ensure optimum water quality for the production of ice cubes (CS 1360 and CS 1350B) an external water filter module is available as an accessory. It should be installed near the appliance in the cabinet, for example, in the adapter cabinet above the appliance.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Cabinet Opening Dimensions: CS 1311, CS 1360, CS 1200, CS 1350B The appliance can be integrated into the kitchen units. To adapt the appliance to the height of the row of kitchen units, a suitable top cupboard can be fitted above the appliance. Unit Venting DO NOT restrict the air flow. A cross-sectional air flow of at least 31" square (200cm²) must be provided.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Cabinet Opening Dimensions: SBS 26S1 The appliance can be integrated into the kitchen units. To adapt the appliance to the height of the row of kitchen units, a suitable top cupboard can be fitted above the appliance. Unit Venting DO NOT restrict the air flow. A crosssectional air flow of at least 62" square (400cm²) must be provided.
Freestanding/Semi Built In Models The cabinet opening height is 84" when using the decorative grille. The decorative grille is deliverable as accessory and is not required for proper operation of the appliance. All ventilation requirements are handled through the toe kick grille on the appliance and this decorative grille is intended to be used as a filler for pre-existing 84" openings. See chapter „Accessories for Liebherr Freestanding Semi Built In Appliances“ page 23.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Ventilation Requirements This type of cabinet must be carefully constructed using the correct dimensions and it must provide suitable ventilation to ensure proper appliance operation. B - Side view Kitchen Cabinet Airflow The following ventilation dimensions must be observed: Cabinet There must be a ventilation space at least 31 in.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Top Door Hinge Clearance CS 13.. - SBS 26S1 When installing CS units into a row of cabinets or wall units; use these dimensions to achieve a custom look with the cabinetry while providing the necessary clearance for the top door hinge. NOTE It is good practice to leave some room for height adjustment of the appliance to accommodate uneven floors.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Top Door Hinge Clearance CS1200 7/16” (11 mm) When installing CS units into a row of cabinets or wall units; use these dimensions to achieve a custom look with the cabinetry while providing the necessary clearance for the top door hinge.
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Door Swing Clearance CS 1200, CS 13..
Freestanding/Semi Built In Models 24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B Accessories for Liebherr Freestanding - Semi Built In Appliances Kits may be necessary to complete this unit's installation or to apply it in a different manner than its original intent. If a kit is necessary, contact your Liebherr retailer or distributor. All installation materials for accessories are included with the kits.
Design Guide Release 11 2015