DesignGuide freestanding semi built in 30,36, and 60 inch 28984 0

General Remarks
II. Electrical Requirements & Safety
A 115 Volt, 60 Hz, 10 Amp (15 Amp for side-by-side
installation) fused electrical supply is required. We rec-
ommend using a dedicated circuit for these appliances
to prevent electrical overload. Comply with the National
Electrical Code as well as local codes and ordinances
when installing the receptacle.
WARNING!
Do not ground to a gas pipe. Check with a
qualified electrician if you are not sure the
appliance is properly grounded. Do not have
a fuse in the neutral or grounding circuit.
WARNING!
ELECTROCUTION HAZARD
Electrical Grounding Required. This
appliance is equipped with a three-
prong(grounding) polarized plug for your
protection against possible shock hazards.
• Donotremovetheroundgrounding
prong from the plug.
• Donotuseatwo-pronggrounding
adapter.
• Donotuseanextensioncordtoconnect
power to the unit.
• Donotuseapowercordthatisfrayedor
damaged.
III. IceMaker (if equipped)
The icemaker is located in the freezer compartment.
It must be connected to the water supply to function
properly. The appliance must be level for the icemaker to
function properly.
The water supply pressure requirements are different
based on whether or not the supplied Liebherr water filter
is installed. With the filter installed, the pressure must be
in the range of 40-90 psi (2.8-6.2 bar). Without the filter
installed the acceptable pressure range is 22-87 psi (1.5-6
bar).
Use a 1/4" OD copper line to connect the water supply to
the solenoid valve. This is not supplied with the appliance.
If you have hard water, we recommend you install a
water softener. Also, a filter must be installed if the water
contains solids such as sand. All equipment and devices
used to supply the water to the appliance must comply
with the current regulations for your geographical area.
Safety Instructions and Warnings
• Donotattachthewatersourcewhiletheapplianceis
connected to an electrical outlet.
• Ashut-offvalve,mustbeinstalledbetweenthehose
line and the main water supply so that the water supply
can be stopped if necessary. Do not install the shut-off
valve behind the refrigeration unit.
• Theconnectiontothewatersupplymayonlybemade
by a trained and licensed plumber.
• Thewaterqualitymustcomplywiththedrinkingwater
regulations for the geographical area where the appli-
ance is located.
• Theicemakerisdesignedexclusivelytomakeice
cubes in quantities needed by a household and may
only be operated with water appropriate for this pur-
pose.
• Allrepairsandworkontheicemakermayonlybedone
by customer service personnel or other trained person-
nel.
• Themanufacturercannotacceptliabilityfordamage
caused by equipment or water lines between the sole-
noid valve and the water supply.