DesignGuide freestanding semi built in 30,36, and 60 inch 28984 0

General Remarks
IV. Area Requirements
Verify the following:
• Floorscansupportrefrigerator’sweightplusap-
proximately 1200 pounds (544 kg) of food weight. Not
all Liebherr products are designed for 1200 pounds
(544 kg) of food. Some units are smaller and total
weights may vary.
• Finishedkitchenoorheightislevel.Refrigeratormust
beshimmedtotheoorlevel,orlevelled,tomakesure,
air vents are not obstructed.
• Removeanythingattachedtotherearorsidewalls
that can obstruct refrigerator opening.
• Cutoutdimensionsareaccurate.
• Electricaloutletisincorrectlocation.
Do not install this unit next to any other refrigerator or
freezer except another Liebherr model. Liebherr models
are designed to allow side by side installation. They are
equipped with a heating system to eliminate condensa-
tion when units are installed side by side. Installing this
unit next to any other refrigerator or freezer can cause
condensation or cause damage to the Liebherr unit.
IMPORTANT
To protect the refrigerator from possible
damage, allow the appliance to stand 1 hour
in place before turning the electricity on.
This allows the refrigerant and system lubri-
cation to reach equilibrium.
CAUTION!
The anti-tip bracket must be installed to
prevent the unit from tipping after it is
installed. Refer to chapter "Blocking For
Safety" in the installation instructions.
V. Safety Regulations
The appliance complies with UL250 and CAN/CSA-C
22.2 No. 63 and is designed to cool, freeze, store food
as well as make ice (if equipped). They are designed for
household use.
These appliances are set to operate within specific ambi-
ent temperature limits according to their climate rating.
These temperature limits should not be exceeded. The
correct climate rating for your specific model is indicated
on the model plate. (See Use & Care Manual.)
This is explained as follows:
Climate
Rating
Set for Ambient Temperatures of
SN 50°F to 90°F (10°C to 32°C)
N 61°F to 90°F (16°C to 32°C)
ST 61°F to 100°F (16°C to 38°C)
T 61°F to 109°F (16°C to 43°C)
SN-ST
SN-T
50°F to 100°F (10°C to 38°C)
50°F to 109°F (10°C to 43°C)
- The refrigerant circuit has been tested for leaks.