Operating instructions

11
operaTion
Temperature Display - Figure 8
Innormaloperation,thefollowingsettingswillbe
displayed:
• theaveragerefrigeratortemperature
• thewarmestfrozenfoodtemperature.
When starting up for the first time or when
the appliance is warm, dashes will appear
inthefreezertemperaturedisplay,untilthe
temperatureinthefreezercompartmentis
32°F(0°C).
Itwilltakebetweenthreeandeighthoursforthe
requiredtemperature,0°For38°F(-18°Cor3°C)to
be reached and displayed permanently in the display,
depending on the ambient conditions and the tempera-
ture setting.
The display will flash:
• ifyouchangethetemperatureor
• ifthetemperaturerisesbyseveraldegrees,indicat-
ingcoldloss,e.g.ifyouplacefresh,“warm”foodin
thefreezerorifyouremoveorrepackfrozenfood,
the temperature may rise for a short time due to
warmairflowingintothefreezer.
• If“F1” to “F5” appears in the display, the appliance
hasafault.Havethefaultnumberavailablewhen
you contact the customer service department.
Audible Alarm Signal - Figure 8
Theaudiblealarmsignalhelpstoprotectfrozenfood
and to save energy.
The audible alarm signal is switched off by touching
the alarm icon.
Audible door alarm
This sounds when the door has been left open
forlongerthanabout180seconds.Thesound
switch-off function is active as long as the door is
left open. The alarm automatically switches back to
standby when the door is shut.
Audible/visual temperature alarm
Italwayssoundsifthefreezertemperatureisnot
low enough. The temperature display and the alarm
LED
flashes at the same time.
Thiscanbecausedby:
- warm,freshfoodbeingplacedinthefreezer;
- too much warm air from the outside entering
whenre-arrangingorremovingfrozenfood,
- a fault in the appliance.
The temperature display will continue to flash until
thecauseofthealarmhasbeenrectied.Itwill
then stop flashing and light up continually. The au-
dible warning signal is now automatically reset.
Power Failure/Frost-Control
Display - Figure 8
IfthepowerfailureLED islit,thismeansthefreezer
temperature has risen too high during the last few
hoursordaysduetoapowerfailure.Thefreezertem-
perature display flashes at the same time.
• IfyoutouchtheAlarm icon now, the highest tem-
perature registered during the power failure will be
displayed.
• Checkthequalityofthefoodincaseithasbecome
too warm or even defrosted.
• Thehighesttemperaturewillappearforapproxi-
matelyoneminute.Afterthat,theactualtemperature
inthefreezerwillreappear.
 ThedisplaycanbeturnedoffbytouchingtheAlarm
icon again.
Supercool - Figure 8
TouchingtheSupercooliconswitchestherefrigerator
compartmenttomaximumcooling.Itisrecommended
particularly if you wish to cool large quantities of food,
drinks, freshly baked goods or meals rapidly.
• Turning on:TouchtheSupercoolicon briefly so the
LED
turns on. The refrigerator temperature will
drop to its lowest value.
IMPORTANT
The Supercool function uses slightly more
energy. After approximately six hours, however,
the refrigerator switches back automatically to
normal energy-saving operation. If required, the
Supercooling function can be turned off sooner.
• Turning off:TouchtheSupercooliconagainuntil
theLED
turns off.