Specifications Sheet
Unit Dimensions
Cabinet Opening Dimensions
Ventilation Requirements
Front view
with 80"
ventilation grille
Top view
A
B
C
B - Side view
Cabinet
Refrigerator
This is a built-in refrigerator-freezer with either custom fi nished door panels or stainless steel doors. The unit
is not intended for freestanding use and has to be installed inside a cabinet. This type of cabinet must be carefully
constructed using the proper dimensions and it must provide proper ventilation to ensure proper appliance operation.
Kitchen Cabinet Airfl ow
The following ventilation dimensions must be observed: There must be a ventilation space at least 31 in.²
(200 cm²) at the airfl ow inlet (1) and at the airfl ow outlet (2).
The top ventilation space can be directed in one of the following ways:
A) Directly over the appliance (2) with an optional factory air vent.
B) Above the cabinet and below the ceiling (3).
C) Through a vent installed in a so t (4).
The refrigerator is designed to allow proper air fl ow when the appliance is installed up against the wall.
A minimum space of 1 1/2" is required when a cabinet is built above.
All units are to open at a minimum of 90° to prevent
problems removing drawers. With the door opening 90°,
you may have to move drawers slightly to clear the door
interior.
• Use a minimum 2“ (51 mm) fi ller, for corner installations,
so the door can be opened to 90°. If you’re using
raised panels, consider using a wider fi ller.
• Use the supplied fi ller strip when units are installed
side by side.
NOTE:
Refer to the minimum door clearances and illustrations at
the end of this section for details on door openings and
fi l l e r s i z e a l t e r n a t i v e s .
The given cabinet opening height dimension includes top
air vent. If you choose to place the vent above the cabinet
or in a so t, you will need to adjust the height dimension
accordingly.
Side view right
24"
Diagrams
Liebherr F 1051
Built-in/Stainless Steel