Operating instructions Freezer Read the operating instructions before switching on for the first time Page 8 GB 7083 105-00 GG 40_GG 52
Disposal notes Range of appliance use The appliance contains reusable materials and should be disposed of properly - not simply with unsorted household refuse. Appliances which are no longer needed must be disposed of in a professional and appropriate way, in accordance with the current local regulations and laws. The appliance is suitable solely for cooling food in a domestic environment or similar.
Safety instructions and warnings • To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. • In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. • To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. • Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse.
Setting up • Do not place the appliance in direct sunlight or near cookers, radiators and similar sources of heat. • The floor on which the appliance stands should be horizontal and level. Compensate for uneven floors with the adjustable feet. Note GG 52 To alter the height, rotate the bottom section of the respective adjustable foot. WARNING! The height of the foot can be adjusted from 150 mm to 180 mm.
Door open alarm If the door is left open for more than 180 seconds, the audible warning signal will sound. If the door must be opened for a lengthy period to place items into the appliance, cancel the audible warning signal by pressing the Alarm button. GB Deactivating the keypad lock Press The alarm switches back to standby when the door is shut. for 5 seconds.
Defrosting Malfunctions • Switch the appliance off to defrost. Pull out the mains plug. • Appliance does not function: – Is the appliance switched on? – Is the plug correctly fitted in the mains socket? – Is the fuse intact? After a longer period of operation a layer of frost or ice can build up on the cooling plates in the freezer compartment. This will increase the energy consumption of the freezer. The cooling plates should therefor be defrosted regularly.
GB Changing over door hinges 1. Remove screw from lower hinge bracket. 2. Lift door, tilt to the right and remove. 5. Turn lower hinge pin through 180° and remove. 6. Insert pin on the opposite side and turn through 180°. 7. Locate door on upper pin. 8. Tilt door inwards from the left. 9. Secure hinge pin with screw. 3. Transfer upper hinge components to the opposite side. 4. Transfer lower hinge bracket and cover plate to the opposite side. 10.