Operating instructions Commercial freezer Read the operating instructions before switching on for the first time Page 10 GB 7082 391-01 GGPv / BGPv
Content Safety instructions and warnings............................................ 11 Noise emissions from the appliance....................................... 11 Range of appliance use........................................................... 12 Climate rating.......................................................................... 12 Appliance dimensions............................................................. 12 Setting up..........................................................................
Safety instructions and warnings • To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. • In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. • To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. • Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse.
Range of appliance use The appliance is suited only for cooling food. The appliance is not suited for storing and cooling pharmaceuticals, blood plasma, laboratory preparations or similar substances and products subject to the Medical Devices Directive 2007/47/EC. Any misuse of the appliance may result in damage to or spoilage of the stored goods. Furthermore, the appliance is unsuited for use in areas exposed to an explosion hazard.
GB Electrical connection Only operate the appliance with alternating current (AC). The permissible voltage and frequency are indicated on the type plate. The position of the type plate is shown in the section entitled Description of the appliance. The socket must be properly earthed and protected by a fuse. GGPv 14.. equipment Fit the supplied shelf rails to the right and left of the vertical bar. The tripping current of the fuse must be between 10 A and 16 A.
Operating and control elements Setting the temperature • Press button 1 sec. The temperature display flashes. • To increase the temperature (warmer): press button • To reduce the temperature (colder): press button • Press button . . again. The desired temperature setting is saved. Audible warning signal - This sounds when the door has been left open for longer than 240 seconds. The audible warning device is switched off by pressing the Alarm button.
Cleaning Clean the appliance at least twice per year. Before cleaning always switch off the appliance. Pull out the mains plug or switch off or unscrew the fuse. • Empty the appliance and store the food in a cool place. • Clean the inside and equipment with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents. Do not use steam cleaners because of the risk of injury and damage.
Changing over door hinges GGPv 65.. / BGPv 84.. Door hinges should only be changed by a trained expert. Changing the door hinges must be done by two people. 1. Open door by about 90°. Important note The door must be opened 90° before the lower hinge bracket is removed. This will hold the self-closing mechanism that is integrated into the door in the required position for installation. 4. Re-fit base mounting bracket on the opposite side.
11. Fit the hinge components on the hinge bracket. GB Bearing ring Brass washer Plastic washer 7. Transfer the upper hinge bracket and covers to the opposite side. 8. Turn the door by 180°. 12. Install the hinge bracket with the fitted hinge components in the lower door mounting. Note on point 12 9. Insert the bearing ring and hinge bushing in the upper door mounting. The tabs on the bearing ring must fit into the recesses of the door mounting during installation.
