Installation Instructions

Mounting the refrigerator door

panels - Figures 24 - 33

The description is for one panel only. The procedure is

the same for both panels.

1. Open the refrigerator door and hang the panel on the

adjusting bolts (Figure 24).

2. Screw on the hex nuts to the adjusting bolts and fin-

ger tighten temporarily (Figure 24).

Figure 24

Figure 25

3. Close the door and check the height of the panel.

4. Align the panel in its vertical position if necessary.

Loosen the hex nuts and turn the adusting bolts using

a screwdriver for slotted screws (Figure 25).

Mounting the freezer drawer

panels - Figure 23

1. Pull out the upper freezer drawer and screw on the

panel with three screws at left and right hand side

using the screws as shown in Figure 23.

2. Close the drawer and check the position to the sur-

rounding cabinet panels. Align the panel in verti-

cal direction by loosening the screws left and right.

Finally tighten the screws.

Donotovertighten.Donotuseapower

driver.

3. Pull out the lower freezer drawer and fasten the lower

panel in the same way.

4. Finally cover the gap between the drawer and the

panel of both freezer drawers with the strips provided.

Remove the foil from the adhesive surface of the strip

and stick on the top of the appliance drawer (Figure

23) making sure the flexible gasket is fully inserted in

the gap.

Screw 3.5 x 13 mm

Figure 23

InStallatIon