Installation Instructions

Mounting the Anti Tipping
Device in Cabinets deeper than
24" - Figure 10 - 11
To ensure the compressor mounting plate reaches the
anti tipping bracket in cabinets deeper than 24", a wood-
en spacer must be mounted between the appliance back
and the wall. The anti tipping bracket will be fastened to
the floor downwards and to the spacer backwards.
Be sure the wooden spacer is fastened
securely to the floor.
Figure 10
Measuring for mounting the wooden spacer on
frameless kitchen cabinets - Figure 11
Figure 11
Panel thickness
Depth of spacer depending on clear-
ance between appliance and wall
Depth of spacer depending on clear-
ance between appliance and wall
Measuring for mounting the wooden spacer on
inset kitchen cabinets - Figure 10
IMPORTANT
If the floor slopes down sideways, the anti-tipping
bracket must be fitted horizontally. Lay down spacers
in the appropriate positions.
Cover Strips - Figure 12
Apply cover strips above, between and below the secur-
ing plates on the side walls of the appliance.
Cut the cover strips to the length shown in Figure 12.
Fit the adhesive cover strips leav-
ing a gap of 1/4" to each
securing plate. This
ensures problem-free
fitting of the covers.
Figure 12
9
BlockIng for Safety