Use and Care Manual
14
operaTion
= Temperature display mode
You can choose the unit of temperature for the dis-
playindegreesFahrenheitordegreesCelsius.
Note
The factory setting is degrees Fahrenheit.
How to change the temperature display to
degrees Celsius
• ActivatethesetupmodebytouchingtheSuperfrost
iconfor5seconds.
• Touchthefreezer compartment Down icon until
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
- the display shows
• TouchtheSuperfrost icon again
- the temperature reading is now displayed in degree
Celsius.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.
Note
To change the temperature display back to degrees
Fahrenheit, follow the steps above.
= WaterquantityforIcecubetray
IftheproducedicecubesoftheIceMakeraretoo
small,theinflowingwaterquantitycanbeadjusted.
Howtoadjustthewaterquantity
• ActivatethesetupmodebytouchingtheSuperfrost
iconfor5seconds.
• Touch the freezer compartment Down icon until
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
- the display shows
• Touchfreezer compartment Up icon
once only so
E 4 appears in the display.
IMPORTANT
Do not increase for more than one step. If the
adjusted value is too high the ice cube tray of the
Ice Maker could overflow.
• TouchtheSuperfrost icon again.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.
Checktheicecubesizewithinthenextdays.Ifthe
ice cubes are still smaller as desired, follow the steps
above again.
Setup Mode - Figure 10
= Display brightness
How to adjust the display brightness
• ActivatethesetupmodebytouchingtheSuperfrost
iconfor5seconds.
• Touch the freezer compartment Down icon until
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
- the display shows
• Touchfreezer compartment
Up/Down icons to select
0 = minimum to
5 = maximum brightness
• TouchtheSuperfrost icon at the desired value.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.