Installation Instructions
Table Of Contents
- 1General safety information
- 2Setting up the appliance
- 3Kitchen cabinet setup
- 4Reversing the door
- 5Water connection*
- 6Installation
- 7Installing the water filter*
- 8Connecting the appliance
- 1Consignes de sécurité générales
- 2Mise en place de l'appareil
- 3Construction du placard
- 4Inversion du sens d'ouverture de la porte
- 5Prise d'eau*
- 6Encastrables
- 7Installer le filtre à eau*
- 8Brancher l'appareil
- 1Notas generales sobre seguridad
- 2Instalación del aparato
- 3Montaje del mueble de cocina
- 4Cambio del tope de puerta
- 5Conexión de agua*
- 6Montaje
- 7Colocación del filtro de agua*
- 8Conexión del aparato
6 Installation
Fig. 13
All fasteners are supplied with the appliance.
Make sure you have the following tools on hand:
q
Cordless screwdriver Torx® 15, 20, 25
q
Hex wrench 13
q
Screwdriver
6.1 Assembling the appliance
Fig. 14
Unit depth less than 21 3/4 in. (553 mm) Detach the
spacers from the rear of the appliance so that you can
slide the appliance completely into the recess. Removing
the spacers may cause the appliance to use more energy,
as this reduces the ventilation cross-section.
Fig. 15
u
Undo the screw
Fig. 15 (50)
and detach the spacer
Fig. 15 (51)
.
All appliances:
u
Remove the power cord from the back of the appli-
ance. Also remove the cable holder, otherwise
there will be vibration noise!
u
Position the power cord using
a piece of string so that the
appliance can easily be
connected to the electricity
supply after it has been built-
in.
Fig. 16
For appliances with a water filter:*
Installation
10 * Depending on model and options