Design Guide

General Remarks
IV. Area Requirements
Verify the following:
• Floorscansupportrefrigerator’sweightplusapproxi-
mately 1200 pounds (544 kg) of food weight. Not
all Liebherr products are designed for 1200 pounds
(544 kg) of food. Some units are smaller and total
weights may vary.
• Finishedkitchenoorheightislevel.Refrigeratormust
beshimmedtotheoorlevel,orlevelled,tomake
sure, air vents are not obstructed.
• Removeanythingattachedtotherearorsidewalls
that can obstruct refrigerator opening.
• Cutoutdimensionsareaccurate.
• Electricaloutletisincorrectlocation.
Do not install this unit next to any other refrigerator or
freezer except another Liebherr model. Liebherr models
are designed to allow side by side installation. They are
equipped with a heating system to eliminate condensa-
tion when units are installed side by side. Installing this
unit next to any other refrigerator or freezer can cause
condensation or cause damage to the Liebherr unit.
NOTICE
To protect the refrigerator from possible
damage, allow the appliance to stand 1/2 to
1 hour in place before turning the electricity
on. This allows the refrigerant and system
lubrication to reach equilibrium.
Blocking For Safety
The anti-tip brackets must be installed to prevent the
unit from tipping after it is installed.
V. Safety Regulations
The appliance complies with UL250 and CAN/CSA-C
22,2 No. 63 and is designed to cool, freeze, store food
as well as make ice (if equipped). It is designed as a
household appliance. If used commercially, the relevant
regulations on commercial use must be observed.
The appliance is set to operate within specific ambient
temperature limits according to its climate rating. These
temperature limits should not be exceeded. The cor-
rect climate rating for your appliance is indicated on the
model plate.
This is explained as follows:
Climate
Rating
Set for Ambient Temperatures of
SN 50°F to 90°F (10°C to 32°C)
N 61°F to 90°F (16°C to 32°C)
ST 61°F to 101°F (16°C to 38°C)
T 61°F to 110°F (16°C to 43°C)
SN-ST
SN-T
50°F to 101°F (10°C to 38°C)
50°F to 110°F (10°C to 43°C)
- The refrigerant circuit has been tested for leaks.