Installation Instructions

Fig. 17 *
u
Slice open the water hose Fig. 17 (52) located behind
the appliance both in front of and behind the connector
Fig. 17 (53) (90° to direction of hose).*
When doing so, make sure the hose does not become
kinked and the cross-section of the hose remains round.*
u
Connect the supplied exten-
sion hoses Fig. 18 (54) to the
appliance hoses Fig. 18 (52) :
Slide the appliance hoses
into the connectors as far as
they will go (approx. 21/32 ''
(17 mm)).*
Fig. 18
u
Position the hoses using a piece
of string so that they can be
connected to the water filter later
(see 3.3) .*
*
Appliances with a plumbed-in connection for the
IceMaker:
u
Connect the IceMaker .*
u
Install the detent clip
Fig. 19 (62) .*
Fig. 19 *
All appliances:
u
Push the appliance 3/4 of the way into the recess.
u
Remove covers Fig. 14 (4,6,7) .
u
Screw Fig. 20 (11) the
equalizer trim Fig. 20 (24)
onto the top of the appli-
ance through the oblong
holes.
Fig. 20
u
Fasten a pair of
mounting brackets
Fig. 21 (12) into the pre-
bored holes in the
appliance door with a
hex head screw
Fig. 21 (13) .
Fig. 21
For large or divided unit doors:
u
Fit a 2nd pair of mounting brackets
Fig. 33 (12) .
u
Use the holes pre-drilled in handle area
of the appliance door for this purpose.
With 5/8 '' (16 mm) thick
unit walls:
u
Clip spacer Fig. 22 (14) and
spacer Fig. 14 (15) onto the
hinge.
Fig. 22
u
Place the covers
Fig. 23 (16) top and
bottom onto the
mounting brackets
Fig. 23 (17) .
u
Fasten the mounting
brackets Fig. 23 (17) on
top with screws
Fig. 23 (19) and on the
bottom with Screws
Fig. 14 (19) such that the
bracket still has a slight
bit of play to the left and
right.
Fig. 23
u
Remove the protective film from the
trim Fig. 24 (20) .
u
Place the trim Fig. 24 (20) on the flange
of the cover Fig. 23 (16) , on the handle
side and flush with the front, and adhe-
sively affix it to the side wall of the
appliance.
u
If necessary, shorten the trim
Fig. 24 (20) at the bottom: The trim
Fig. 24 (20) must end 1/8 '' (3 mm)
above the upper edge of the bottom
mounting bracket Fig. 14 (17) .
Fig. 24
Insert and align appliance:
u
Slide the appliance in until it contacts Fig. 23 (16) the
covers Fig. 23 on the side wall of the unit.
With 5/8 '' (16 mm) thick
unit walls:
u
Slide the appliance into the
recess until it touches the
spacers on the side wall of
the unit.
Fig. 25
With 3/4 '' (19 mm) thick
unit walls:
u
Align the front edges of the
hinges flush with the side
wall of the unit.
Fig. 26
Units (5/8 '' (16 mm) and 3/4 '' (19 mm)) with door
stop components (knobs, sealing lips, etc.):
Installation
11