Installation Instructions

u
To align the crosspiece Fig. 31 (31) : Mark a short center
line on the unit door and put the tip of the arrow on the
crosspiece on it. Then slide the crosspiece
Fig. 31 (31) 3/16 in. (5.5 mm) toward the hinge side.
For chipboard doors:
u
Secure the crosspiece Fig. 31 (31) with at least 6 screws
Fig. 31 (34) .
For frame and panel doors:
u
Secure the crosspiece Fig. 31 (31) with 4 screws
Fig. 31 (34) at the edge.
u
Lift up the fitting aids Fig. 31 (30) , turn around and insert
into the adjacent openings.
Fig. 32
u
Attach the unit door on the adjusting bolts Fig. 32 (33)
and loosely screw the locknuts Fig. 32 (32) onto the
adjusting bolts.
u
Close the door.
u
Check the gap between the door and the surrounding
unit doors.
u
To laterally align the unit door: Move the unit door in the
X direction.
u
To align the unit door in the Y direction (height) and in
lateral inclination: Adjust the adjusting bolts Fig. 32 (33)
with a screwdriver.
w
The unit door is flush and in alignment with the
surrounding unit fronts.
u
Tighten the locknuts Fig. 32 (32) .
Fig. 33
Ensure that both metal edges are flush, symbol //:
u
Drill pilot holes in the door of the unit taking care not to
go all the way through the panel (you could make a
preliminary hole with a bradawl).
u
Screw the appliance door to the unit door with screws
Fig. 33 (34) through the mounting brackets Fig. 33 (12) .
Fig. 34
u
To align the unit door in depth Z: Undo top screws
Fig. 34 (35) , bottom hex head screws Fig. 34 (13) , then
move the door.
u
Do not allow the knobs and sealing
lips to contact the door - important for
functioning!
u
Set an air gap of 3/32 '' (2 mm)
between the door of the unit and the
body of the unit.
Fig. 35
u
Check the fit of the door and re-adjust, if necessary.
u
Tighten all screws.
u
Tighten the locknuts
Fig. 35 (32) with the ring wrench
Fig. 35 (38) , while counter-holding the adjusting bolts
Fig. 35 (33) with a screwdriver.
u
Position the upper cover
Fig. 36 (39) and snap into
place.
u
Place the lateral cover
Fig. 36 (40) in position,
slide to the limit and then
press until it snaps audibly
into place.
u
Attach covers Fig. 36 (41)
to the side and then draw
them forward with a
screwdriver, so that they
snap properly into place.
Fig. 36
With a 24 '' (609.6 mm) wide recess:
u
Position the covers Fig. 14 (6,7,42) and snap them into
place.
With a 23-5/8 '' (600 mm) wide recess:
u
Position the covers Fig. 14 (4,6,7) and snap them into
place.
Check the following points to make sure the appliance is
installed correctly. Otherwise, icing up, the formation of
condensate, and malfunctions can occur.
w
The door must close properly.
w
The unit door must not touch the body of the unit.
w
The seal on the upper corner on the handle side must
be fitted securely. To verify this, darken the room, place
a flashlight in top part of the appliance, and close the
door. If you see light shining out, check the assembly.
Installation
13