Installation Instructions

Disconnect the power plug.
Open the door.
4.1 Detaching the soft stop mecha-
nism
Fig. 8
CAUTION
Risk of injury if soft stop contracts!
u
Carefully remove soft stop damper.
u
Use a screwdriver to slide the tension spring
Fig. 8 (11)
outwards.*
u
Remove the soft stop mechanism Fig. 8 (2) by pulling it
downwards.
u
Unscrew the retainer Fig. 8 (1) .
u
Unscrew the ball stud Fig. 8 (3) (Torx® 25).
4.2 To remove the door
Fig. 9
u
Remove the covers
Fig. 9 (4) .
u
Just loosen the fixing screws Fig. 9 (5) .
u
Remove door: Push outwards, unhook and put to one
side.
4.3 Swapping bearing parts
CAUTION
Hinges are spring-loaded and can cause pinching inju-
ries!
u
Leave hinges open.
u
Swap the fixing screws
Fig. 9 (5) on the top and
bottom to the opposite
side.
The screws are self-
tapping. Use a cordless
screwdriver:
u
Unscrew Fig. 10 (9) the
hinges from the door,
move to the other side
and secure tightly by
applying a screw
torque of 3 lb-ft (4 Nm).
u
Close off the now unused
holes with plugs
Fig. 10 (10) .
Fig. 10
4.4 Installing the door again
u
Hang the appliance door on the pre-fitted fixing screws
Fig. 9 (5) .
u
Tighten the fixing screws Fig. 9 (5) securely by
applying a screw torque of 3 lb-ft (4 Nm).
u
Re-attach the covers Fig. 9 (4) .
4.5 Re-attaching the soft stop mecha-
nism
Fig. 11
u
Screw the
Fig. 11 (3) ball stud securely into the new
fastening hole by applying a torque of 3 lb/ft (4 Nm)
(Torx® 25).
u
Slide the tension spring Fig. 8 (11) inwards again.*
u
Tightly screw on theretainer Fig. 11 (1) by applying a
torque of at least 2.5 lb-ft (3 Nm).
u
Attach the soft stop mechanism Fig. 11 (2) onto the ball
stud.
Reversing the door
8