Use and Care Manual

3 Controls and displays
3.1 Operating and control elements
Fig. 2
(1) Temperature display (5) SuperCool button
(2) Down button (6) Alarm button
(3) Up button (7) Child safety symbol
(4) On/Off button
3.2 Temperature display
The following is displayed in normal operation:
-
the average fridge temperature
The following displays indicate malfunction. Possible
causes and corrective actions: (see Troubleshooting).
-
F0 through F5
4 Start-up
4.1 Transporting the appliance
CAUTION
Risk of injury or damage if incorrectly transported.
u
Transport the appliance in its packaging.
u
Transport the appliance upright.
u
Do not move the appliance on your own.
4.2 Setting up the appliance
WARNING
Risk of fire due to moisture!
If live parts or the power cord get wet, this can cause a
short circuit.
u
The appliance is designed for use in enclosed spaces.
Do not operate the appliance in open space or in damp
areas or where there is spray.
u
Only operate the appliance after it has been installed.
WARNING
Risk of fire due to short circuit.
If the power cable or plug of the appliance or another
appliance and the back of the appliance touch each other
the power cable or plug will be damaged by the vibrations
of the appliance which could lead to a short circuit.
u
Install the appliance so that it does not touch any plugs
or power cables.
u
Do not connect the appliance or other appliances to the
sockets on the back of the appliance.
WARNING
Danger of fire and damage!
u
Do not place devices that give off heat, e.g. micro-
waves, toasters, etc. on the appliance.
CAUTION
Risk of personal injury!
u
Have two people move this appliance into place.
NOTICE
Risk of damage caused by condensation
Installing the appliance next to any other refrigerator or
freezer can cause condensation or damage to the Lieb-
herr appliance.
u
Do not install this appliance next to any other refriger-
ator or freezer except another Liebherr model. Liebherr
models are designed to allow side-by-side installation.
They are equipped with a heating system to eliminate
condensation when refrigerators or freezers are
installed side-by-side.
NOTICE
Risk of damage for the finished floor surface!
u
Protect the finished floor surface before you uncrate the
unit.
Verify that:
q
The floor under the appliance is flat and level.
q
The floor can support the appliance's weight plus
approximately 1200 pounds (544 kg) of food weight.
q
The appliance is not placed in direct sunlight or near
the stove, range top, radiators and similar heat
sources.
q
The kitchen cabinet that the appliance is installed in is
shimmed to the floor level if the floor heights are not
equal.
q
Cutout dimensions are accurate.
q
Electrical outlet is in correct location.
q
The air flow is not restricted. Air flow must be provided
for the appliance to operate properly. The factory air
vents provide 31 square inches (200 cm
2
) of air flow
per appliance. If you are replacing the air vents with an
overlay, the air flow must be the same or greater than
the factory air vents.
Controls and displays
5