Operating and installation instructions Combined fridge-freezer with BioFresh compartment for integrated use, door-on-door 010410 7084282 - 03 ICB/ICBP/ICBN/SICBN ...
Appliance at a glance Contents 1 1.1 1.2 1.3 1.4 Appliance at a glance............................................ Description of appliance and equipment.................. Range of appliance use............................................ Conformity................................................................ Saving energy.......................................................... 2 2 2 3 3 2 General safety information................................... 3 3 3.1 3.2 Controls and displays............
General safety information Furthermore, the appliance is unsuited for use in areas exposed to an explosion hazard. The appliance is set to operate within specific ambient temperature limits according to its climate rating. The correct climate rating for your appliance is indicated on the type plate. Note u Compliance with the ambient temperatures indicated is required, otherwise the cooling performance is reduced.
Putting into operation (2) SuperFrost button (3) On/Off button freezer compartment (4) Down setting button freezer compartment (5) Up setting button freezer compartment (6) Temperature display freezer compartment (8) Child lock symbol (9) Down setting button refrigerator compartment (10) Up setting button refrigerator compartment (11) On/Off button refrigerator compartment (12) SuperCool button u Lower soft stop mechanism Fig. 3 (2) for removal. u Unscrew holder Fig. 3 (1). u Unfasten ball stud Fig.
Putting into operation WARNING Risk of injury due to the door dropping out! If the fastening parts are not screwed into place firmly enough, the door may drop out. This may lead to severe injuries. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw the hinges and the ball journal of the soft stop mechanism firmly into place, with 4 Nm. u Screw the holder of the soft stop mechanism firmly into place, with at least 3 Nm.
Putting into operation 4.3.1 Installing the appliance Fig. 7 Fig. 8 u Detach the connecting cable from the rear of the appliance. Remove the cable holder otherwise there will be vibratory noise. u Lay the connecting cable with the help of string in such a way that the appliance can be easily connected following installation. Fig. 9 For appliances with permanently plumbed in IceMaker: u Connect the IceMaker (see 4.2) . All appliances: u Slide the appliance 3/4 of the way into the recess.
Putting into operation u Fit the equaliser trim Fig. 10 (20) concentrically onto the appliance: Slide it into the recess and engage it in the keyholes. u Screw all the mounting brackets Fig. 11 (34) to the pre-drilled holes in the appliance door using hexagon screws Fig. 11 (35). For 16 mm-thick unit walls = 568 mm-wide recess: u Clip spacer Fig. 12 (23) onto the upper hinge and spacer Fig. 8 (24) onto the lower hinge. u Attach the top cover Fig. 13 (53) and bottom cover Fig.
Putting into operation u Check 8 mm-presetting. (Distance between appliance door and lower edge of crosspiece) u Slide up the assembly aids Fig. 20 (30) to the height of the unit door. Lower stop edge ▲of the assembly aid = upper edge of the unit door to be fitted. u Unscrew the crosspiece Fig. 21 (31) by undoing the locknuts Fig. 21 (32). u Attach the crosspiece Fig. 21 (31) together with the assembly aids Fig. 21 (30) to the inside of the unit door. Fig.
Putting into operation Check the following points to ensure the appliance is fitted properly. Failure to do so may lead to icing, condensate forming and malfunction: w The door has to close properly w The unit door must not butt against the unit body w The seal must have a firm fit at the upper corner on the handle side. To check, darken the room, place a torch inside the appliance at the top and close the door. If light shines through, check the assembly. 4.
Control Put the appliance into operation about 2 hours before first loading food to be frozen. Do not load food to be frozen before the temperature display reads -18 °C. 4.8.1 Switching on the freezer compartment u Press On/Off button, freezer compartment Fig. 2 (3). w The refrigerator compartment temperature display shows the set temperature. w The temperature display of the freezer compartment and the alarm button flash until the temperature is sufficiently low.
Control u Use recyclable plastic, metal, aluminium and glass containers and cling film for wrapping. u Use the front area of the refrigerator compartment floor only for briefly putting down cooled products, e.g. when rearranging and sorting. However do not leave cooled products there otherwise they may be pushed back or tipped over when the door is closed. u Do not store food too close together to enable good air circulation. u To safeguard bottles from tipping over: move the bottle holder.
Control 5.6.2 DrySafe The DrySafe is suitable for storing dry or wrapped food (e.g. dairy products, meat, fish, sausages). A relatively dry storage climate is established here. Standard values for storage time at high humidity Spinach up to 13 days Savoy cabbage up to 20 days Fruit 5.6.
Control 5.6.6 Setting the humidity in the HydroSafe u u Low humidity: move the regulator to the left. High humidity: move the regulator to the right. 5.6.7 Drawers Fig. 28 u Remove drawers as illustrated. u To remove drawer cover: once the drawers have been removed, carefully pull the drawer cover with humidity control forwards and lower it for removal. 5.7.3 Setting the temperature in the freezer compartment The appliance is pre-set for normal operation.
Control Using cold storage accumulators* u Freeze and store the cold storage accumulators in the ceiling of the freezer compartment (appliances without No-Frost module). u To store frozen food directly on the shelves: pull the drawer forwards and lift it out. 5.7.6 Shelves u To remove the shelf: lift up at the front and pull out. u To put the shelf back: simply push in as far as it will go. 5.7.
Maintenance Switching off the IceMaker* If no ice cubes are needed, the IceMaker can be switched off independently of the freezer compartment. When the IceMaker is switched off, the IceMaker drawer can also be used for freezing and storing food. u Press the On/Off button for about 1 second until the LED goes out. u Clean the IceMaker. w This ensures that no water or ice remains in the IceMaker. 6 Maintenance 6.1 Manual defrosting The refrigerator compartment is defrosted automatically.
Malfunction 7 Malfunction 6.4 Cleaning the IceMaker* Fig. 32 The IceMaker has to be switched on. u Pull out the drawer and remove the ice cubes. u Clean the drawer with warm water and mild washing-up liquid. u When the drawer is pulled out, hold down the On/Off button (about 10 seconds). w After about 1 s the LED goes out, the IceMaker is switched off. w After about 10 s the LED flashes for about 60 s. u Slide in the drawer while the LED is flashing.
Decommissioning u alarm button Fig. 2 (1)Press w The warmest temperature reached during the power failure will appear in the temperature display for about 60 s. After that, the actual temperature in the freezer will re-appear. u To prematurely cancel the display of the warmest temperature: press alarm button Fig. 2 (1). u Check the quality of the food. Do not consume spoiled food. Do not re-freeze thawed food. The IceMaker cannot be switched on.
Disposing of the appliance 18