Installation instructions

u
Use recyclable plastic, metal, aluminium and glass containers
and cling film for wrapping.
u
Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over when
the door is closed.
u
Do not store food too close together to enable good air circu-
lation.
u
To safeguard bottles from tipping over: move the bottle holder.
At the base of the refrigerator compartment, the integrated bottle
shelf or alternatively the glass shelf can be used:
u
To use the bottle shelf:
store the glass shelf
compactly under the
bottle shelf.
u
Place the bottles with the
base pointing backwards
facing the rear wall.
If the bottles project
beyond the bottle shelf:
u
set the lower door rack
one position higher.
5.5.2 Setting the temperature
The temperature can be set from 9 °C to 4 °C / Australia model
9 °C to 3 °C, the recommended temperature is 5 °C.*
Note*
If the temperature is to be colder than 4 °C/3 °C*:
u
set the cooling temperature to 4 °C/3 °C*.
u
Set the BioFresh temperature to a value between b4 (slightly
colder) and b1 (coldest) (see 5.6) .
u
For a higher temperature setting: press Up button, refrigerator
compartment Fig. 2 (10) .
u
For a lower temperature setting: press Down button, refriger-
ator compartment Fig. 2 (9) .
w
The first time the button is pressed, the value set so far is indi-
cated in the refrigerator compartment temperature display.
u
To change the temperature in 1 °C steps: briefly press the
button.
u
To change the temperature continuously: hold down the
button.
w
The value is displayed flashing during the setting operation.
w
The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.5.3 SuperCool
With SuperCool you switch to the highest cooling performance
to reach lower cooling temperatures. Use SuperCool, to rapidly
cool large amounts of food.
When SuperCool is activated, the fan runs. The appliance oper-
ates with maximum refrigeration. The noise of the refrigeration
unit may be temporarily louder as a result.
The SuperCool function uses slightly more energy.
Cooling with SuperCool
u
Briefly press SuperCool button
Fig. 2 (12) .
w
The SuperCool button Fig. 2 (12) lights up.
w
The cooling temperature drops to the coldest value. Super-
Cool is activated.
w
SuperCool is automatically deactivated after 6 to12 hours The
appliance continues to operate in the energy-saving, normal
mode.
To prematurely deactivate SuperCool
u
Briefly press SuperCool button Fig. 2 (12) .
w
The SuperCool button Fig. 2 (12) goes out.
w
SuperCool is deactivated.
5.5.4 Relocating the shelves
The shelves have stops preventing them from being unintention-
ally pulled out.
u
Insert shelf with the raised edge pointing upwards at the back.
w
The food does not freeze onto the rear wall.
5.5.5 Using the sectioned shelf
Fig. 27
u
Attach the support rails, paying attention to the right (R) and
left (L) part!
u
The glass shelf with stop face (2) has to be at the back.
Always remove the butter and cheese
compartment together with the lid.
u
To remove lid: Press one side part of
the butter and cheese compartment
outwards until the lid pin is clear and
then remove the lid sideways.
5.5.7 Removing the bottle holder
u
Always take hold of the bottle holder on
the plastic part.
5.6 BioFresh compartment
The BioFresh compartment allows some types of fresh food to
be stored up to three times longer than in conventional refriger-
ators, without compromising quality.
For food with an indicated best before date, the date specified
on the packaging always applies.
5.6.1 HydroSafe
The HydroSafe at the moist setting is suited for storing
unwrapped salad, vegetables and fruit with high inherent mois-
ture. When the drawer is well filled, a dewy climate with up to 90%
humidity is established. The humidity in the compartment
depends on the moisture content of the food stored and on the
opening frequency. You can set the humidity yourself.
Control
11