Operation Manual

(7) Alarm symbol (17) Freezer compartment tem-
perature display
(8) Up setting button, freez-
er compartment
(18) SuperFrost symbol
(9) Down setting button,
freezer compartment
(19) IceMaker symbol
(10) On/Off button, freezer
compartment
3.2 Temperature display
-
the warmest freezing temperature
-
the average BioFresh temperature
The freezer compartment temperature display flashes:
-
the temperature setting is being changed
-
after switch-on the temperature is not yet cold enough
-
the temperature has risen several degrees
The following displays indicate malfunction. Possible causes and
corrective action (see Malfunction).
-
F0 to F9
-
FE
-
The power failure symbol shines.
4 Putting into operation
4.1 Changing over the door hinges
You can change over the door hinges if necessary.
NOTICE
Risk of damage to side-by-side appliances due to condensation!
When a Side-by-Side appliance (S…) is fitted together with a
second appliance (as a SBS combination), the door hinges must
remain as delivered.
u
Do not change over the door hinges.
Ensure that the following tools are to hand:
q
Torx 25
q
Torx 15
q
Screwdriver
q
Cordless screwdriver, if necessary
q
Second person for fitting work, if needed
4.1.1 Detaching the upper door
Note
u
Remove any food from the door racks before removing the
door, so that no food falls out.
Fig. 4
u
Close the upper door.
u
Pull off the cover Fig. 4 (1) forwards and upwards.
u
Lift off the cover Fig. 4 (2)
CAUTION
Risk of injury if the door tips!
u
Take good hold of the door.
u
Set down the door carefully.
u
Unscrew the upper turn hinge
Fig. 4 (3) (2 Torx 25) Fig. 4 (4)
and raise it for removal.
u
Lift up the upper door and set it aside.
4.1.2 Detaching the lower door
u
Close the lower door.
u
Draw the middle bearing pin
Fig. 5 (11) out of the turn hinge
and lower door.
u
Remove the plastic cap Fig. 5 (10) .
CAUTION
Risk of injury if the door tips!
u
Take good hold of the door.
u
Set down the door carefully.
u
Open the lower door.
u
Detach the middle turn hinge Fig. 5 (13) .
u
Lift up the door and set it aside.
4.1.3 Transferring the middle bearing elements
Fig. 5
u
Carefully detach the cover panel Fig. 5 (12) .
u
Turn the middle turn hinge Fig. 5 (13) 180° and transfer it to
the new hinge side.
u
Turn the cover panel Fig. 5 (12) through 180° and snap it into
place again on the new handle side.
4.1.4 Transferring the lower bearing elements
Fig. 6
u
Draw the safety lock Fig. 6 (21) .
Putting into operation
4