Assembly and installation instructions

Close the door and check the position of the panel.

IMPORTANT

If the door has to be limited to a 90° opening angle,

it must be done before the panel is mounted onto

the appliance door. See chapter „Important Note

for Changing over Door Hinges or Limiting the

Hinges to a 90° Opening Angle“.

IMPORTANT

After a certain time

and loading, it may be

necessary to readjust

the door again.

IMPORTANT

Risk of damaging the panel.

Do not undershoot the minimum panel thickness

(shaker style).

Position the panel support strips with the top lug in the

cut of the top attachment bracket.

Align the panel support strips parallel to the side edge

of the panel and screw into place with twelve 4 x 14

screws.

Tx™ 15

Open the appliance door.

Place the door panel on the top adjusting bolts and

align in the centre.

Screw the hex nuts onto the adjusting bolts and tighten.

Move the mounting strips from the refrigerator door to

the freezer door.

nStallatIon