Assembly and installation instructions

Only use countersunk screws

for handle mounting.

The holes should be counter-

sunk.

The screw heads should be

flush with the panel.

IMPORTANT

Risk of damaging the panel.

Do not undershoot the

minimum panel thickness

(shaker style).

Position the panel support strip with the top lug in the

cut-out of the attachment bracket.

Align the panel support strip parallel to the side edge of

the panel and screw into place with 4 x 14 screws.

Tx™ 15

IMPORTANT

If the door has to be limited to a 90° opening angle,

it must be done before the panel is mounted onto

the appliance door. See chapter „Important Note

for Changing over Door Hinges or Limiting the

Hinges to a 90° Opening Angle“.

Complete the same procedure for the left-hand door.

Move the mounting strips from the refrigerator door to

the freezer door.

nStallatIon