Installation Instructions

1.
2.
3.
1. Mark the center line of the appliance on the back
wall.
Align the anti-tipping bracket center to this line.
WARNING!
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Drill a 3/8" diameter hole in any position as shown in
Figure 4 using a carbide drill bit.
The depth of the holes must exceed the overall length
of the anchors.
Clean the holes after drilling.
3. Attach washer and screw on hex nut to the end of
each anchor.
Drive in all 3 anchors.
Align the bracket center to the center line on the back
wall again.
Fasten the anchors by turning the hex nut.
4. Fasten bracket with 3 screws (1/4" x 2-3/8") into the
wall plate (Figure 5).
4.
Figure 5
Wall
Mounting the anti-tipping device on concrete
floors - Figure 4 - 5
Figure 4
Wall
15
B lockIng for S afety
Wall Plate
Wall Plate