Assembly and installation instructions

Remove the transit supports

using the Torx 25 key.

Raise the appliance evenly by turning the screws suc-

cessively until the appliance back touches the anti-

tipping bracket (lift approx. 1/4" / 6.5 mm).

To attain the minimum base panel height of 4"

(102 mm), the adjustable feet must be raised by 1/4"

(6 mm) to 5/16" (8 mm).

Maximum height adjustment of the appliance = 3/4"(19mm)

IMPORTANT

When turning the screws with a power driver please

consider absolutely.

Maximum rotation speed = 400 rpm

Maximum torque = 8.8 lbs/in (1 Nm)

Failure to follow this instruction will result in

damage to the height adjustment unit.

DANGER!

Risk of death or serious injury due to

appliance tipping.

Do not open the appliance door before the

height adjustment is finished and the anti-

tipping bracket supports the appliance.

Turn clockwise to raise the appliance.

Fasten the appliance in the

recess through the appliance

cover strips using eight screws

4 x 14 for each side. We recom-

mend that you mark and pre-drill

the hole positions in the strip.

Mount the ventilation grille with the grille

segments tilted down.

Remove the depth adjustment aid before fastening the

appliance in the recess.

Tx™ 15

Close the front part of the

appliance cover strips.

Hint:

Use the removed transpor

tation safety component to

help with closing.

Pull the freezer drawer

upwards by its right and left

bottom corners (1). Push the

container backwards (2). Set

the container to an angle and

remove it (3).

nStallatIon