Assembly and installation instructions

33
I nStallatIon
Insert the door racks.
The gallon rack must be in the
lowest possible position of the
clip-in strip.
Insert the hooks of the rack
into the openings of the clip-in
strip at the desired height and
push down.
IMPORTANT
Be sure each door rack is fixed properly in the clip-
in strip.
Open the shut-off valve for the water supply and
check the entire water system for leaks.
Please note in case of removing
appliance from the recess
If the appliance has to be removed from the recess
again, please make sure you take account of the follow-
ing.
1. Unload the appliance.
2. Disconnect the appliance from the power source.
3. Remove the door panels.
4. Lower the appliance using the height adjustment unit.
DANGER!
Risk of death or serious injury due to
appliance tipping.
Do not remove the appliance without the
mounted transit supports.
5. Mount the transit supports with
two screws for each support
using a Torx 25 key.
Important Note for Changing
over Door Hinges or Limiting the
Hinges to a 90° Opening Angle
Changing the door hinges or limiting the hinges to a 90°
opening angle should only be carried out by a trained
expert.
The door hinges are fitted with strong closing springs. If
the hinge accidentally snaps shut, this can lead to seri-
ous injury.
The door itself is very heavy. Do not try to dismount the
door yourself.
Contact the Liebherr service for more information. See
contact details on the back of this manual.
SmartDeviceBox (Not Supplied
in All Countries)
Download the “SmartDevice
App” to your smartphone.
Start the app on your smart-
phone and follow the instruc-
tions.