Assembly and installation instructions

Open the appliance door.

Place the door panel on the top adjusting bolts and

align in the centre.

Screw the hex nuts onto the adjusting

bolts and tighten.

Close the door and

check the position of the

panel.

IMPORTANT

If the door has to be limited to a 90° opening angle,

it must be done before the panel is mounted onto

the appliance door. See chapter “Important Note

for Changing over Door Hinges or Limiting the

Hinges to a 90° Opening Angle” on page 21.

IMPORTANT

After a certain time

and loading, it may

be necessary to

readjust the door

again.

Align the panel hori-

zontally with the long

holes in the attach-

ment bracket.

Tighten the hex nuts.

Align the panel in its vertical

position if necessary.

Align the panel in its

depth.

Loosen the screws,

align the panel and

tighten the screws.

Loosen the hex nuts

and turn the adust-

ing bolts with the

Torx 15 key provided.

Maximum adjustment: 15 mm (5/8")

nStallatIon