Install Guide

Open the appliance door.
Place the door panel on the top adjusting bolts and
align in the centre.
Screw the hex nuts onto the adjusting
bolts and tighten.
Use the 10 mm wrench pro-
vided.
Close the door and
check the position of the
panel.
IMPORTANT
If the door has to be limited to a 90° opening angle,
it must be done before the panel is mounted onto
the appliance door. See chapter “Important Note
for Changing over Door Hinges or Limiting the
Hinges to a 90° Opening Angle” on page 21.
IMPORTANT
After a certain time
and loading, it may
be necessary to
readjust the door
again.
Align the panel hori-
zontally with the long
holes in the attach-
ment bracket.
Tighten the hex
nuts. Use the 10 mm
wrench provided.
Align the panel in its vertical
position if necessary.
Align the panel in its
depth.
Loosen the screws,
align the panel and
tighten the screws.
Loosen the hex nuts
and turn the adust-
ing bolts with the
Torx 15 key provided.
Maximum adjustment: 15 mm (5/8")
18
I nStallatIon