Installation Guide

12
B lockIng for S afety
Mounting the anti tipping device
in cabinets deeper than 24" -
Figure 1- 2
To ensure the compressor mounting plate reaches
the anti tipping bracket in cabinets deeper than 24", a
wooden spacer must be mounted between the appli-
ance back and the wall. The anti tipping bracket will
be fastened to the floor downwards and to the spacer
backwards.
WARNING!
Be sure the wooden spacer is fastened
securely to the floor.
Figure 1
Measuring for mounting the wooden spacer on
frameless kitchen cabinets - Figure 2
Figure 2
Panel thickness
Depth of spacer depending on clear-
ance between appliance and wall
Depth of spacer depending on clear-
ance between appliance and wall
Measuring for mounting the wooden spacer on
inset kitchen cabinets - Figure 1
IMPORTANT
If the floor slopes down sideways, the anti-tipping
bracket must be fitted horizontally. Lay down
spacers in the appropriate positions.
Mounting the anti tipping device
on wooden floors - Figure 3
1. Mark the center line of the appliance on the back
wall. Align the anti tipping bracket center to this line.
WARNING!
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Fasten bracket to the wooden floor using 5 screws
(1/4" x 2-1/8"). Drill pilot holes if necessary.
3. Fasten bracket with 3 screws (1/4" x 2-1/8") into the
wall plate.
Figure 3
Wall Plate
Wall