Assembly and installation instructions

12
B lockIng for S afety
Position anti-tipping device - Figure 1- 2
The anti-tipping bracket will be fastened to the floor
downwards and to the spacer backwards.
WARNING!
Be sure the wooden spacer is fastened
securely to the floor.
Figure 1
Frameless kitchen cabinets - Figure 2
Figure 2
Panel thickness
anti-tipping device
anti-tipping device
A wooden spacer must be mounted
between the appliance back and the
wall (height 1-1/2").
A wooden spacer must be mounted
between the appliance back and the
wall (height 1-1/2").
Inset kitchen cabinets - Figure 1
IMPORTANT
If the floor slopes down sideways, the anti-tipping
bracket must be fitted horizontally. Lay down
spacers in the appropriate positions.
Mounting the anti-tipping device on wooden
floors - Figure 3
1. Mark the center line of the appliance on the back
wall. Align the anti-tipping bracket center to this line.
WARNING!
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Fasten bracket to the wooden floor using 5 screws
(1/4" x 2-3/8"). Drill pilot holes if necessary.
3. Fasten bracket with 3 screws (1/4" x 2-3/8") into the
wall plate.
1.
2.
3.
Figure 3
Wall
Anti-tipping device
Secure the appliance in place so it does not tip forward
when the fully stocked door is opened.
The anti-tipping
bracket is provided with the appliance.
• May only be installed by trained personnel.
• The (1/4" x 2-3/8") screws are designed for standard
dry walls.
• If the anti-tipping bracket cannot be secured properly
using the (1/4" x 2-3/8") screws, use suitable anchors
or different screws.
IMPORTANT
Cabinet depth min. 25"
Wall Plate