Manualshelf

Use and Care Manual with Installation Instructions

ManualsBrandsLiebherr ManualsDomestic AppliancesRO510
11121314151617181920
19
T
roubleshooTing
Customer Service
If none of the above possible causes apply, and
you can not rectify the
fault yourself, contact the
Liebherr Service Center.
Indicate the type (1) of
appliance, service num-
ber (2) and the appliance /
serial number (3) as shown
on the model plate.
The position of the model plate is shown in the section
entitled Description of the Appliance.
Your appliance is designed and manufactured for a long life and reliable operation.
If a problem occurs during operation, check whether it is due to an operating error.
Please note that even during the warranty period, you may be responsible for certain repair costs.
Problem Possible cause and remedy
Appliance does not work, display is
off.
- Is the appliance turned on?
- Is the power cord properly inserted in the outlet?
- Is the circuit breaker or fuse in working order?
Motor seems to
run too long.
- Is the ambient temperature too hot? See Safety Regulations.
- Has the appliance been opened too often or left open too long?
The temperature is
not cold enough.
- Is the temperature setting correct? See Setting the Temperature.
- Has an excessive amount of fresh food been placed in the appliance?
- Does a separately installed thermometer show the correct reading?
- Is the ventilation system working properly?
- Is the dust filter in the appliance base dirty? See section entitled
Cleaning.
- Is the appliance set up too close to a heat source?
The fans inside the appliance are
running even though the fan function
has been deactivated and the com-
pressor (refrigeration unit) is idle.
- This is a normal operating state depending on the set interior tempera-
ture and ambient temperature at the place of installation.
F1 appears in the display. - A fault has occurred in the appliance. Contact the Liebherr Service Center.
When inserting the mains plug, the
refrigeration unit does not switch on,
but a value is shown in the tempera-
ture display.
– Demo mode is activated. Contact the Liebherr Service Center.