Operating instructions Freezer 240816 7085576 - 01 SGN(es)/GN(es) ...
Appliance at a glance Contents 1 1.1 1.2 1.3 1.4 1.5 1.6 1.7 Appliance at a glance............................................ Geräte- und Ausstattungsübersicht.......................... Appliance range of use............................................. Conformity................................................................ External dimensions of the appliance....................... Saving energy.......................................................... Insulation plate.................................
General safety information Climate classifications Depending on the climate classification the appliance is designed to operate in restricted ambient temperatures. The climate classification applying to your appliance is printed on the rating plate. Note uKeep to the specified ambient temperatures in order to guarantee that the appliance works properly.
Controls and displays unless they are under continuous adult supervision. - When disconnecting the appliance from the supply, always take hold of the plug. Do not pull the cable. - In the event of a fault pull out the mains plug or deactivate the fuse. - Do not damage the mains power cable. Do not operate the appliance with a defective mains power cable.
Putting into operation (6) Temperature display 3.2 Temperature display During normal operation, the display shows: - the highest freezing temperature The temperature display flashes if/when: - You change the temperature setting - The appliance is not cold enough after switching on - The temperature rises by several degrees Stripes flash in the display if/when: - The freezer temperature exceeds 0 °C. The following displays indicate a fault. Possible causes and solutions: (see Malfunction).
Putting into operation u In the case of an appliance with enclosed wall spacers, mount the wall spacers on the back of the appliance at the top left and right. u Dispose of packaging material (see 4.5) . u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. 4.3.1 Detaching the door Fig. 4 u Close the door. u Pull off the cover Fig. 4 (10) forwards and upwards. u Lift off the cover Fig. 4 (11).
Putting into operation u Unscrew Fig. 6 (29)the bearing element Fig. 6 (28) transfer it to the opposite location hole of the turn hinge and screw it firmly into place. u Re-insert the stopper Fig. 6 (21) into the other hole. u Undo the screw Fig. 6 (27) and transfer it to the opposite side. u Screw the turn hinge Fig. 6 (25) firmly into place on the new hinge side, possibly using a cordless screwdriver (with 4 Nm). u Re-insert the bearing pin Fig. 6 (22) together with the washer and adjustable-height foot*.
Control 4.5 Disposing of packaging WARNING Risk of injury due to the door dropping out! If the bearing parts are not screwed into place firmly enough, the door may drop out. This may lead to severe injuries. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw the turn hinges firmly into place with 4 Nm. u Check all of the screws and retighten if necessary. 4.
Control 5.1.1 Adjusting the brightness 5.4 Temperature alarm The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity). u To activate the setting mode: press the SuperFrost button Fig. 3 (8) for about 5 s. w The display indicates c. w The menu symbol Fig. 3 (3) shines. u Using the Up setting button Fig. 3 (1) or Down setting button, Fig. 3 (2), select h. u To confirm: briefly press the SuperFrost button Fig. 3 (8). u To make the display brighter: press Up button Fig. 3 (1).
Maintenance u To change the temperature continuously: hold down the button. w The value is displayed flashing during the setting operation. w The actual temperature is displayed approx. 5 seconds after the button is last pressed. The temperature gradually adjusts to the new value. 5.10 Shelves u To remove the shelf: lift up at the front and pull out. u To put the shelf back: simply push in as far as it will go. 5.8 SuperFrost With this function you can freeze fresh food quickly through to the core.
Malfunctions 6.2 Cleaning the appliance WARNING WARNING Risk of injury and damage as a result of hot steam! Hot steam can lead to burns and can damage the surfaces. u Do not use any steam cleaners! NOTICE Incorrect cleaning damages the appliance! u Do not use cleaning agents in concentrated form. u Do not use any scouring or abrasive sponges or steel wool. u Do not use any sharp or abrasive cleaning agents, nor any that contain sand, chloride or acid. u Do not use chemical solvents.
Decommissioning u The sound is normal. A hum. It is briefly a little louder when the refrigeration unit (the motor) switches on. → The refrigeration increases automatically when the SuperFrost, function is activated, fresh food has just been placed in the appliance or the door has been left open for a while. u The sound is normal. → The ambient temperature is too high. u Solution: (see 1.2) Vibratory noise. → The appliance is not fixed to the ground.
Disposing of the appliance * Depending on model and options 13
Liebherr-Hausgeräte Ochsenhausen GmbH Memminger Straße 77-79 88416 Ochsenhausen Deutschland home.liebherr.
