User Manual

Fig. 17
u
Remove the cover and fix it on the other side. Fig. 17 (1)
u
Place the bearing bracket on the other side and screw in
with the aid of a T25 screwdriver. Start with screw 2 at the
bottom in the middle. Fig. 17 (2)
u
Screw in screws 3 and 4. Fig. 17 (3, 4)
u
Insert the bearing pin completely. Make sure that the catch
mechanism is pointing to the rear. Fig. 17 (5)
4.3.5 Moving the door bearing parts to the
other side
For appliances without a soft top mechanism:*
Fig. 18 *
u
Underside of door faces upwards: Turn the door.*
u
Push the tab downwards with a slotted screwdriver.*
Fig. 18 (1)
u
Pull the door latch out of the guide.* Fig. 18 (2)
u
Push the door latch into the guide on the other side.*
Fig. 18 (3)
u
Upper side of door faces upwards: Turn the door.*
4.3.6 Moving the handles to the other side
For all appliances:*
Fig. 19
u
Pull off the cover.
Fig. 19 (1)
u
Remove the screws with the T15 screwdriver.
Fig. 19 (2)
u
Remove the handle.
Fig. 19 (3)
u
Carefully lift up the side plugs with a slotted screwdriver and
pull them out.
Fig. 19 (4)
u
Insert the plugs again on the other side.
Fig. 19 (5)
Putting into operation
* Depending on model and options 11