Installation Guide

Fig. 13
The air flow cavity must be at least 200 cm².
The unit's energy consumption will increase if there is insuffi-
cient air flow.
Fig. 14
Fix the foam pad in the middle of the plinth panel.
The foam pad is used to separate the incoming and outgoing
air flow and allows sufficient ventilation.
Type of fixing on the kitchen unit
Side fixing
q
Base frame under a hard worktop, such as granite.
q
The appliance is lower than the work surface when the
adjusting feet are fully extended.
q
Pre-requisite: Side unit wall available for screw connection.
Top fixing
q
The appliance is slightly braced under the work top when
the adjusting feet are fully extended.
q
No granite plate.
2.7.1 Installing the appliance
Fig. 15
u
If already in place, pull the plinth panel forwards.
u
Detach the connecting cable from the rear of the appli-
ance, removing the cable holder at the same time
because otherwise there will be vibratory noise!
u
Lay the connecting cable with
the help of a string in such a
way that the appliance can be
easily connected after fitting.
Fig. 16
NOTICE
Risk of harm to flooring susceptible to damage!
u
Place a strip of cardboard under the height-adjustable feet,
approx. 10 cm x 60 cm, one at either side. Cut the strips out
of the packaging. For opening heights less than 826 mm,
use strips of a firm but thin material.
u
After the appliance has been slid in, remove the strips.
Top fixing
Fig. 17
u
Insert the bracket into the holder on the top of the unit and
bend towards the front.
u
Slide the unit into the recess and level, see Levelling the
appliance.
Putting into operation
* Depending on model and options 7