Operating instructions

Defect Cause Remedy
DEMO lights up
in the tempera-
ture display.
The outside
surfaces of the
appliance are
hot*.
The heat of the refrigerant circuit
is used to prevent condensate from
forming.
u
This is normal.
The temperature
is not cold
enough.
The door of the appliance is not
closed properly.
u
Close the appliance door.
Insufficient ventilation.
u
Clear and clean the ventilation grille.
The ambient temperature is too high.
u
Solution: (see 1.3 Range of appliance use)
The appliance was opened too
frequently or for too long.
u
Wait to see whether the required temperature resets
itself by itself. If not, contact the customer service
department (see 6 Maintenance) .
Too much fresh food was placed
inside without SuperFrost.
u
Solution: (see 5.9 SuperFrost)
The temperature is incorrectly set.
u
Set to a colder temperature and check after 24 hours
The appliance is too near to a heat
source (stove, heater etc).
u
Change location of appliance or the heat source.
The appliance was not properly
installed in the recess.
u
Make sure the appliance was installed correctly and
the door closes properly.
The interior light
does not turn
on.
The appliance is not switched on.
u
Switch on the appliance.
The door was open for longer than
15 min.
u
The interior light automatically switches itself off if the
door remains open for approx. 15 min.
The LED interior light is faulty or the
cover is damaged:
WARNING
Risk of injury from electrical shock.
Live parts are under the cover.
u
The LED interior light should only be replaced or
repaired by the Customer Service department or by
engineers trained to do so.
WARNING
Risk of injury from LED lamp!
The light intensity of the LED lighting corresponds to risk
group RG 2.
If the cover is faulty:
u
Do not gaze directly at this lighting unit with optical
lenses while very close to the light source. This can
cause damage to your eyes.
The door seal
is defective
or should be
replaced for
other reasons.
The door seal is interchangeable.
You can replace it without the use of
any special tools.
u
Contact the customer service department
(see 6 Maintenance) :
Troubleshooting.
* Depending on model and options 13