Assembly and installation instructions

Fig. 32
u
Screwing the unit door to the appliance door.
u
Drill pilot holes in the door of the unit (you could make a
preliminary hole with a bradawl)
u
Screw the appliance door to the unit door with screws
through the mounting brackets.
Fig. 33
u
Align the unit door in depth Z : loosen the upper and
lower screws on the door, then move the door.
u
To ensure better access to the screws below the door,
open the door approx. 45°.
u
Do not allow the knobs and
sealing lips to contact the door -
important for function
u
Set an air gap of 1/16 '' (2 mm)
between the unit door and the
body of the unit.
Fig. 34
u
Check the fit of the door and re-adjust, if necessary
u
Tighten all screws
u
Tighten the locknuts Fig. 34 (10) with a hex wrench 13,
while counter-holding the adjusting bolts Fig. 34 (13)
with a screwdriver.
Fig. 35
u
Position the upper cover and snap it into place.
Check the following points to make sure the appliance is
installed correctly Otherwise, icing up, the formation of
condensate, and malfunctions can occur
w
The door must close properly
w
The unit door must not touch the body of the unit
10 Disposal of packaging
WARNING
Danger of suffocation from packaging materials and films!
u
Do not allow children to play with packaging materials.
The packaging is made from recyclable materials:
-
Corrugated card/cardboard
-
Parts made of foamed polystyrene
-
Films and bags from polyethylene
-
Packing bands from polypropylene
-
Wood frame nailed together with a polyethylene
window*
u
Take the packaging material to an official collection
point.
11 Connecting the appliance
WARNING
Electrical shock hazard!
u
Start-up should only take place once the appliance has
been installed according to these instructions.
u
Electrically ground appliance.
u
Do not ground to a gas pipe.
u
Check with a qualified electrician if you are not sure the
appliance is properly grounded.
u
Do not have a fuse in the neutral or grounding circuit.
u
Do not use an extension cord, power bar or a multiple
socket adapter.
u
Do not use a power cord that is frayed or damaged.
Disposal of packaging
* Depending on model and options 13