Assembly / Installation Guide

Fig. 27
u
Check the 5/16 '' (8 mm) presetting. (Distance between
appliance door and lower edge of crosspiece)
u
Raise the fitting aids Fig. 27 (12) to unit door height.
Bottom stop edge of ▲the fitting aid = top edge of the
unit door to be fitted.
u
Unscrew the crosspiece Fig. 27 (11) by undoing the
locknuts Fig. 27 (10) .
Fig. 28
u
Hang the crosspiece Fig. 28 (11) on the inside of the unit
door using the fitting aids Fig. 28 (12) .
With a 23-5/8 '' (600 mm) wide recess:
u
Align the crosspiece Fig. 28 (11) to the middle of the
door.
With a 24-1/32 '' (610 mm) wide recess:
u
Align the crosspiece (11) to the middle of the door.
u
Left strip: Move the crosspiece (11) 1/4 (6 mm) to the
left.
-or-
u
Right strip: Move the crosspiece (11) 1/4 (6 mm) to the
right.
For chipboard doors
u
Secure the crosspiece Fig. 28 (11) with at least 6 screws
Fig. 28 (19) .
For frame and panel doors
u
Secure the crosspiece Fig. 28 (11) with 4 screws
Fig. 28 (19) at the edge.
u
Lift up fitting aids Fig. 28 (12) , turn round and insert into
the adjacent openings.
Fig. 29
u
Attach the unit door on the adjusting bolts Fig. 29 (13)
and loosely screw locknuts Fig. 29 (10) onto the
adjusting bolts.
u
Close the door.
u
Check the gap between the door and the surrounding
unit doors
u
To laterally align the unit door Move the unit door in the
X direction.
u
To align the unit door in the Y direction (height) and in
lateral inclination: Adjust the adjusting bolts Fig. 29 (13)
with a screwdriver.
w
The unit door is flush and in alignment with the
surrounding unit fronts
u
Tighten the locknuts Fig. 29 (10) .
Fig. 30
u
Screwing the unit door to the appliance door.
u
Drill pilot holes in the door of the unit (you could make a
preliminary hole with a bradawl)
u
Screw the appliance door to the unit door with screws
through the mounting brackets.
Fig. 31
u
Align the unit door in depth Z : loosen the upper and
lower screws on the door, then move the door.
Installation
12 * Depending on model and options