Operating Instructions

Problem Possible Cause Correction
The temperature
display shows a
flashing power
failure symbol
. The
warmest temper-
ature reached
during the power
failure is
displayed in the
temperature
display.
The freezer temperature rose too
high during the last hours or days
due to power failure or power inter-
ruption. When the power interruption
is over, the appliance will continue to
operate at the last temperature
setting.
u
To delete the display of the warmest temperature:
Press the Alarm button
Fig. 2 (5) .
u
Check the quality of the food. Do not consume
spoiled food. Do not re-freeze defrosted food.
DEMO lights up
in the tempera-
ture display.
The demo mode is activated.
u
Contact the customer service department (see Main-
tenance).
The outside
surfaces of the
appliance are
hot*.
The heat of the refrigerant circuit is
used to prevent condensate from
forming.
u
This is normal.
The temperature
is not cold
enough.
The door of the appliance is not
closed properly.
u
Close the appliance door.
Insufficient ventilation.
u
Clear and clean the ventilation grille.
The ambient temperature is too high.
u
Solution: (see 1.3)
The appliance was opened too
frequently or for too long.
u
Wait to see whether the required temperature resets
itself by itself. If not, contact the customer service
department (see Maintenance).
Too much fresh food was placed
inside without SuperFrost.
u
Solution: (see 5.9)
The temperature is incorrectly set.
u
Set to a colder temperature and check after 24 hours
The appliance is too near to a heat
source (stove, heater etc).
u
Change location of appliance or the heat source.
The appliance was not properly
installed in the recess.
u
Make sure the appliance was installed correctly and
the door closes properly.
The interior light
does not turn
on.
The appliance is not switched on.
u
Switch on the appliance.
The door was open for longer than 15
min.
The LED interior light is faulty or the cover is damaged:
The LED interior light is faulty or the
cover is damaged:
WARNING
Risk of injury from electrical shock.
Live parts are under the cover.
u
The LED interior light should only be replaced or
repaired by the Customer Service department or by
engineers trained to do so.
Troubleshooting.
12 * Depending on model and options