User Manual

29
GB
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it o and disconnect the plug or switch o or remove the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
54
56
55
53. Place the appliance in its final position at the place of instal-
lation.
Extend the adjustable foot at the bottom hinge bracket until
it rests on the floor and then make a further 90° turn.
54. Release cover on the inside and slide to
the outside.
Adjusting the lateral tilt of the door
If the door is at an angle, adjust the angle.
Front view of top hinge bracket
55. Turn cover downwards.
56. Undo screws and slide hinge bracket
to the right or left.
Tighten screws.
Re-fit cover following the instructions
above in reverse order.
Close door and check that it is
aligned with the side walls of the
appliance.
49
52
50
51
49. Move soft stop mechanism hinge to the
fastener.
50. Insert pin.
51. Remove red safety
bracket.
52. Click cover into place.
53