Full Product Manual

14
Pre - Operating Instructions: Assembly
WHEEL KIT INSTALLATION:
The Following Tools are needed to Install Wheel Kit:
 Safety Glasses
 8mm - 14mm Wren ch S et
 8mm - 14mm Ratc h et & So cket S et
 17mm Ratchet & Socket
Wheel Kit Installation Directions:
NOTE: Install Wheel Kit BEFORE Filling the Generator with Fuel or Oil. Never Tip a Unit that contains Fuel or Oil.
1. Tip Generator so Engine End is up.
2. Slide Axle through both Mounting Brackets.
3. Place a Wheel on both Sides as shown in “Assembly Diagram.”
4. Securely Tighten Wheel nuts with the 17mm Socket.
5. Tip the Alternator End of the Generator up.
6. Place the Support Legs under the Frame Brace as shown in “Assembly Diagram.”
7. Secure with the provided Cap Screws and Hex Nuts. Securely tighten using 12mm Ratchet and Socket.
2 Support
Legs
2 Handles
2 Wheels